2. Computers & electronics
  3. Telecom & navigation
  4. Telephones
  5. VTech
  6. DS6405A

VTech DS6405A Registration Instructions

  • Hello! I am an AI chatbot trained to assist you with the VTech DS6405A Registration Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
Place the supplied rechargeable battery in the battery compartment, with the battery connector plugged in, as
shown above.
Slide the battery compartment cover back on until it clicks into place.
Place the handset on the charger to charge for at least 16 hours.
NOTES
Use only the supplied NiMH rechargeable battery.
If you do not use the handset for a long time, disconnect and remove the batteries to prevent possible leakage.
1.
2.
3.
•
•
Plug one end of the power cable into the charger base.
Plug the other end into the power wall socket and switch the power on.
NOTE
Ensure power cord is fed through the slot on the charger so unit sits ush with the desk.
Install and Charge the Handset Battery
1.
2.
DS6405A ADDITIONAL HANDSET REGISTRATION INSTRUCTIONS
This additional handset has been designed to operate with the DS6475-2A telephone system. Please refer to your
DS6475-2A user’s manual for instructions on general functionality.
Package Contents
1 DS6405A handset
1 Charger
1 AC power adaptor
1 NiMH rechargeable battery pack
Connect the Charger
The position in which you place the DS6405A charger could have an effect on the range and performance of
your DS6405A.
•
•
•
•
1
2
2
Registering an Additional Handset
The additional handset must be registered to the telephone base before use. Follow the instructions below to register
a cordless handset to your DS6475-2A.
To register a Handset
Make sure the unregistered handset is not on the base or charger cradle.
Put the unregistered handset on the base, the screen shows “Registering... Please wait”. The indicator on the
base turns on. The registration process takes up to 90 seconds.
If the registration is successful , the handset screen shows “HANDSET X Registered” (X stands for the handset
number) briey. The indicator on the base turns off. The handset will return to idle mode. Repeat the steps above
if the registration failed.
If you have any problems with your phone, refer to the TROUBLESHOOTING section of your
DS6475-2A User’s manual.
FOR MORE INFORMATION CALL (852) 2667 7433.
1.
2.
3.
DIGITAL HEADSET CORDLESS PHONE
DIGITAL HEADSET CORDLESS PHONE
/