e model may di er from the illustration above.
* Your HD channels: the availability of high-de nition content depends on your installation and whether you are in an area covered by the HD signal.
You can check this at www.belgacom.be/tv or in a Belgacom shop.
e decoder
e equipment will have been installed either by you or by an engineer.
Nevertheless, if you need to disconnect the cables, refer to the installation guide
for instructions on reconnection. Depending on which model you have, the
decoder display will show the following:
e remote control
e remote control communicates with the decoder
so you need to point the remote at the decoder.
Changing channel is slower with digital television.
Follow the instructions on page 60 to make your
life easier by using only one remote control for
Belgacom TV and your television.
• HD indicates that the content you are watching is being
broadcast in
* (high de nition)
.
• indicates that a signal is being transmitted.
• REC indicates that a recording is in progress.
ON the left there are 4 lights on the decoder display:
• the
or
POWER
light ashes when the decoder is
receiving information from the remote control;
• the SIGNAL light indicates that the decoder is on;
• the HD light indicates that the content you are watching
is being broadcast in
*
;
• the RECORD light indicates that recording is in progress.
Don't forget to replace the batteries in the
remote control, preferably every year.
Model
no 1
Model
no 2
Model
no 3
is model has a battery indicator
Before starting
Belgacom TV
e Belgacom TV decoder is connected to your television in exactly the same way
asany other device (DVD player, Playstation etc.).
Use the remote control for your television to change to the appropriate source
(Scartor HDMI) and see the Belgacom TV screen.
Only use one remote control!
You can use your remote control to control your
television and your decoder. You must rst make
yourremote control a universal remote.
Choose your remote control below depending on the type:
Have you done everything you need to? From now on you can:
• switch your decoder on and o using the
button to use Belgacom TV
• switch your TV on and o using the
button
• switch between the external sources connected to your television using
the
button
• adjust the volume using the
buttons
Have you done everything you need to? From now on you can:
• switch your TV or decoder on and o using the
button
If the e indicator is lit, this means that you are controlling
your decoder. If the e indicator is lit, this means that you can
control your television; press to switch from the TV to the decoder.
• switch between the external sources connected to your television using
the button.
• the volume buttons are roughly similar.
For more information on
using the remote control,
seepage 60.