Page is loading ...
Studio Ultima ANC Over-Ear Headphones
User Guide
Important: pTron ‘Studio Ultima’ is set at 50% default volume. You can increase the volume through the headset or
through the connected device.
TO CHARGE THE CHARGING CASE
i. Connect the charging cable to the headset's charging port.
ii. Connect the other end of the cable to a USB power source (e.g., computer, wall adapter).
iii. The LED indicator will show a charging status ( red while charging and blue when fully charged).
POWER ON/OFF
i. Press and hold the power button for a few seconds to turn the headset on or off.
Pairing with Devices:
i. Turn on the headset, the headset will automatically go to Bluetooth mode, and LED indicator red & blue flashes
rapidly.
ii. Turn on the Bluetooth on your device, and search “ pTron BT”
iii. Tap "pTron BT" to connect. Headset will respond with a voice prompt: " pTron BT connected."
iv. When the Bluetooth signal is lost, the headset will respond with a voice prompt "DISCONNECTED" and will shut
down automatically after 5 minutes.
v. When the headset power on, the headset will connect to the last paired device automatically. If not, please
repeat the above steps.
Basic Operation:
i. Power on/off: Turn on/off the headset by long press the power button.
ii. Volume control: Press one time “+” button to increase the sound and Press one time “-” to decrease the sound.
iii. Play/Pause: Press the power button once to start or pause audio playback.
iv. Next/Previous track: Long press the “+” & “-” buttons to move to the next & previous track when playing music.
v. Mode Button : Press the Mode button to change the headset mode ( Normal Mode and ANC mode)
“M button”
“- button”
“+ button”
“Power button”
Call Control:-
i. To Answer A Call: Press the power button once.
ii. To End A Call: Press the power button once.
iii. To Reject A Call: Long press(2 to 3 sec) the power button
iv. To Redial A Call: Press the power button twice.
Voice Assistant:Press 3 time power key to activate default smart voice assistant. The respective voice assistant
screen pops up on the connected and you may place your command.
Tips: You may try out the following commands
Wired Connection(3.5mm Aux):
i. To use a wired connection, connect one end of the 3.5mm audio cable to the headset AUX IN port
ii. Connect the other end of the audio cable to the headphone jack of your audio source (phone, tablet, computer,
etc.).
Troubleshooting:-
Scenario 1 : Connectivity Issue
a. Turn OFF the Headset and charge 100%.
b. Unpaired with the connected Bluetooth device.
c. Restart the Bluetooth device.
d. After 100% charging switch ON the Headset and pair it with the Bluetooth device again..
Scenario 2 : Headset Disconnecting During a Phone Call
a. Headset must be 100% charged before using (low battery can also cause call drops).
b. Unpair the Headset with your connected device and restart the device.
c. Pair the Headset again.
Important: Please use this Headset within a 10 metre wireless range from the connected device.
Safety Precautions
Keep the device out of extreme heat and humidity.
Play time may vary depending on personal habits,
Using incompatible USB cable or high voltage chargers can damage the product & void the product
warranty. We strongly recommend using a good quality DC5V-1A chargers & the USB cable included in the
package.
Please don't over-charge the product as it will decrease the service life of battery.
Read all warnings on the product and in the operating instructions.
It is recommended to utilize the product below the maximum volume in order to protect hearing and extend
headset service life.
Please don’t open/temper the product or product’s battery.
Please keep the product out of children’s reach.
Stop using this product immediately if it causes discomfort or pain.
Dispose the product responsibly and adhere to your local authority guidelines.
Packing Box Content
1 Headset, 1 USB Type-C charging cable, 1 Aux cable & 1 User Manual/Warranty QR Card
What is the weather ?
Take a selfie.
What is Covered in Warranty?
Manufacturing defects in materials and workmanship of the product ONLY. This warranty applies when the
product is used under normal conditions and the purpose for which the product was designed.
No warranty on product accessories such as aux cable, small charging USB cables.
To avail warranty, Product Registration is Mandatory at https://ptron.in/apps/product-registration
Please read through the complete warranty details at https://ptron.in/pages/repair-service-warranty
Customer Care Details:
Mail: [email protected]
Tel: 040 - 67138888
Service Centers List: https://ptron.in/pages/ptron-service-centers
Disclaimer: The colour and specifications shown in or mentioned in the user manual may differ from the actual
product. Images shown are for representation purposes only. Other product logos and company names mentioned
herein may be trademarks or trade names of their respective owners.
/