10mm Fire Station
B10-CS-009
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Note: We recommend painting the components of this model BEFORE construction. See below for
details.
Ground Floor
Take the front, back and side walls plus the four
triangular bracers from the sprue.
Glue two of the bracers to the back of each of the side
walls as shown above.
Then attach the front and back walls.
Take the door pieces.
Glue one behind each of the doorways.
We suggest you paint your model at this point
(see below)
Take the outer frames (paint them first)
Attach them to your model.
(model shown unpainted)
The model once painted.
Middle Layer
Tae the walls and triangular bracers from the
sprue.
Glue bracers to the back of each end wall (as shown
above)
Glue the front anc back walls into place.
The connetors pieces.
Turn the model upside down and glue the
connector pieces into position.
We now suggest you paint your model (see
below)
The outer frames (paint them first)
Attach them to your model.
(model shown unpainted)
The model once painted.
The Roof Layer
Take the wall and roof piece shown above from
the sprue.
Note – this roof piece has one edge strip wider
then the other three.
Glue that wider edge to the wall.
Take the other roof and the front wall.
Glue them all together as shown.
Take the other walls.
Note – these have additional holes in the lower
half of the walls – these holes are not used in this
kit.
Work around the building adding each wall in turn.
The roof edge strips.
Glue them into position around the tops of the walls.
The connector strips.
Turn the model upside down and glue them into place.
The outer frames
Attach them to your model.
(model shown unpainted)
The model once painted.
Painting
It is much easier to paint your model before construction.
The two roof panels, the roof edge strips, four “roller” doors
and all the outer frames were all removed from their sprues
and sprayed white using a car undercoat aerosol spray.
Once dry, the roller doors had their bottom strip painted with
red and yellow diagonal stripes using model paints.
The walls were sprayed with a red-oxide car undercoat aerosol
spray.
Once dry, the window frames and side doors were picked out
using white model paint.
Connectors and bracers were left unpainted.
After construction any edges can be tidied up using model paint.
-
1
-
2
-
3
-
4
BLOTZ B10-CS-009 Assembly Instructions
- Type
- Assembly Instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BLOTZ B15-CS-251 Operating instructions
-
BLOTZ B15-OW-001 Assembly Instructions
-
BLOTZ B20_MD_002 Assembly Instructions
-
BLOTZ B20_JP_004 Assembly Instructions
-
BLOTZ B15-CS-005 Assembly Instructions
-
BLOTZ B28-ME-010 Assembly Instructions
-
BLOTZ B10_CS_003 Assembly Instructions
-
BLOTZ B06-MW-002 Assembly Instructions
-
BLOTZ B10-MW-003 Assembly Instructions
-
BLOTZ B28-VSF-004 Assembly Instructions
