0070_vx1_manual_1.1_out.indd 1 25/10/2011 16:55
0070_vx1_manual_1.1_out.indd 2 25/10/2011 16:55
06
05
02 03
04
07
08
09
01
10
11
12
0070_vx1_manual_1.1_out.indd 3 25/10/2011 16:55
01
01
02
02
0070_vx1_manual_1.1_out.indd 4 25/10/2011 16:55
01
1
Charging Charged
0070_vx1_manual_1.1_out.indd 5 25/10/2011 16:55
0070_vx1_manual_1.1_out.indd 6 25/10/2011 16:55
Gioteck hereby declares that this
controller is in compliance with the
essential requirements and other
provisions of Directive 1999/E/EC.
To view the full version of the Declaration
of Conformity please go online to
doc.gioteck.com.
Gioteck hereby declares that this
controller is in compliance with the
essential requirements and other
provisions of Directive 1999/5/EC.
To view the full version of the Declaration
of Conformity please go online to
doc.gioteck.com.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation. The device and its antenna
must not be co-located or operating in
conjunction with any other antenna or
transmitter. Gioteck are not responsible
for any interference caused by un-
authorized changes to this equipment.
This equipment generates, uses, and
can radiate radio frequency energy and,
if not installed correctly, may cause
harmful interference to radio
communications. If this equipment does
cause harmful interference to radio/
television reception try the following:
•Reorient or relocate the receiving
antenna. •Increase distance between the
equipment & receiver. •Connect the
equipment into an outlet on a circuit
dierent from the receiver. •Consult
the dealer or a radio/TV technician.
0070_vx1_manual_1.1_out.indd 7 25/10/2011 16:55
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE 1: The manufacturer is not responsible for any changes or modifications not expressly
approved by the manufacturer for compliance, such modifications could void the user’s authority
to operate the equipment.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
