Pergo MG001895 Installation guide

Type
Installation guide

This manual is also suitable for

Jan20_Wallbase P.1
Wallbase Installation Instructions
Wallbase
1. Measure the length of the wall where the wallbase will be installed.
2. Cut the wall base with a miter saw, circular saw or hand saw to the necessary length.
3. Place the wallbase against the wall and test the t.
4. Nail the wallbase into the wall studs with nishing nails.
5. Fill nail holes with coordinating putty.
6. Use quarter round to cover the ooring expansion gap at the wall base.
  • Page 1 1

Pergo MG001895 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI