![](//vs1.manuzoid.com/store/data-gzf/88ad365d0ebb560676269d2d69bf2a1f/2/000445185.htmlex.zip/bg4.jpg)
HP Part No.
A5513-90004
Copyright © 1999
Hewlett-Packard Company
Printed in USA E1299
Copyright and Trademark Information
The information in this document is subject to change without
notice.
Hewlett-Packard makes no warranty of any kind with regard to
this document, including, but not limited to, the implied
warranties of merchantability and fitness for a particular
purpose. Hewlett-Packard shall not be held liable for errors
contained herein or direct, indirect, special, incidental or
consequential damages in connection with the furnishing,
performance, or use of this material.
Warranty. A copy of the specific warranty terms applicable to
your Hewlett-Packard product and replacement parts can be
obtained from your local Sales and Service Office.
© 1999 Hewlett-Packard Company, all rights reserved.
Reproduction, adaptation, or translation of this document
without prior written permission is prohibited, except as allowed
under the copyright laws.
UNIX is a registered trademark of The Open Group.
Safety Information
WARNING
All inputs/outputs are Safety Extra Low
Voltage (SELV) circuits.
CAUTION
The hardware contains electronic components
that can be damaged by static electricity. To
avoid damage, follow these guidelines:
• Store the hardware in its conductive plastic
bag.
• If possible, work in a static-free area.
• Handle circuit boards by the edges only.
Do not touch electronic components or electrical traces. We
strongly recommend that you use a grounding wrist strap that is
connected to the metallic chassis of the host computer. If you do
not have a wrist strap, touch the chassis before handling
adapters and frequently thereafter to equalize any static charge.
LED Safety Information
The optic module provided in the HP A5513A HP-PCI ATM/155
adapter meets LED AEL Class 1 requirements per
EN 60825-1:1994 (+ A11) and EN 60825-2:1994.
Wavelength: 1300 nm.
Regulatory Information
Optic Module
The optic module provided in the HP A5513A and A5515A
HP-PCI ATM/155 adapters conforms to the ITU-T
recommendation G.957 cat I-1 or I-4.
For the United States
Federal Communications Commission (FCC) Radio Frequency
Interference Statement.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference and (2) this device must accept any
interference received, including interference that might cause
undesired operation.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of the
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
Hewlett-Packard’s system verification tests were conducted with
HP-supported peripheral devices and cables, such as those
received with the system. Changes or modifications to this
equipment not expressly approved by Hewlett-Packard could
void the user’s authority to operate the equipment.
For Canada
For Canadian Regulations ICES-003.
Complies with Canadian Electromagnetic compatibility (EMC)
Class A requirements.
Conforme à Classe A des normes canadiennes de compatibilité
électromagnétique (CEM).
For Europe
This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may
be required to take adequate measures.