ReliaBilt 5182027 User manual

Brand: ReliaBilt

Model: 5182027

Type: User manual

ReliaBilt 5182027 is a solar-powered LED address sign that automatically turns on at sunset and off at sunrise. It features a waterproof design and a USB charging port for extended periods without direct sunlight. You can customize your message by writing on the sign with the included waterproof pen and erasing it with a wet cloth. The sign also includes different lighting modes, including RGB and white, to suit your preference.

RELIABILT

# 5182027

DIY SOLAR LED ADDRESS SIGN

INSTALLATION AND HOW TO USE

Locate the best location for your DIY Solar LED Address Sign. For best results, it is recommended that the sign is placed

where it receives adequate sunlight throughout the day.

The light turns ON and Off automatically at sunset and sunrise.

To illuminate either house number, holiday greetings, or other messages, simply wipe away the current message with a

wet cloth using water or a basic household cleaner and then rewrite your new message.

This Solar Powered LED Address Sign is equipped with a USB charging port if experiencing an extended period without

direct sunlight.

1 - Address sign plaque

1 - Waterproof pen

1 - Water-Soluble paintbrush

SECURITY INFORMATION

CAUTIONS: The packing contains small parts that could be swallowed by children. Keep the packaging material

away from children and pets (danger of suffocation).

This solar powered address sign is not a toy.

For safety reasons it is not allowed to rebuild and/or to change the solar address sign luminaire.

Clean the solar module regularly with a damp towel.

To clean the water-soluble paint with a wet cloth, and clean the waterproof paint with a basic USA cleaner or

household alcohol.

Please pay attention to an appropriate start-up. Never attempt to repair defective parts yourself. Repairs must be carried

out only by qualified specialist.

Charging cable included, close the soft cover tightly after charging to prevent the infiltration of rainwater.

How To Install

1. Clean the board.

7. Press switch to Auto, choose the lighting mode as you like.

For RGB Mode - Turn the button to the left .

For White Mode - Turn the button to the right.

2. Write the Information you want to display.

8. Hang sign on the screws.

1 - Charging cable

1 - Cleaning cloth

WELCOME TO

1108

WELCOME TO

1108

WELCOME TO

1108

9. If experiencing an extended period without direct

sunlight, you can charge the sign using the type-c

charging port. After charging is completed, insert the soft

cover to prevent exposure to moisture or dirt and debris.

SETTING UP AND INITIATION

Package Included:

2 - Screws& anchors

1 - Install guide card

3. Once you have located the desired placement for the

sign, use the Install Guide Card to mark the correct

position for two screws. For best results, install sign

where it can receive direct sunlight.

4. Drill two holes using a 1/4" drill bit.

Ø1/4"

Ø4mm

Ø6mm

5. Tap the anchor into the hole you drilled.

6. Drive the screw into the anchor.

* Don't drive the screw all the way in. Leave a small distance

between the screw head and the surface of the wall for hanging.

ReliaBilt 5182027 User manual

ReliaBilt 5182027 User manual

ReliaBilt 5182027 User manual

Related papers

Other documents