Rechargeable LED Night Light
How to use ?
1. Use as portable light
Press the side button, front panel light turns on, press it again, top light turns
on, press one time more and light will turn off.
2. Use as motion sensor night light
In darkness, front panel light will automatically light up to low brightness setting,
it will change to high brightness setting when motion is detected, it will go back
to low brightness setting in approximately 30s, with undetected motion.
At daytime or a bright area, the night light will be on for approximately 15s when
plug into outlet if there is no power outage, and then turn off automatically,
whenever if there is motion detected or not.
3. Use as emergency light / power failure light
When unit is plugged into outlet, front panel light will turn on automatically
when there is a power outage.
How to charge the night light ?
Plug into outlet and the unit will automatically charge when there is no power outage, it
will stop charging automatically, when it is fully charged.
Please note: if there is a wall switch or fixture switch, please keep that switch on,
otherwise the unit will not charge.
Specification
Dimension
111*58*30mm
Weight
94g
Input Voltage
AC120V 60Hz
Battery
3.7V 500mAh
Charging Time
12 hrs
Time Delay
30s+-5s
Detect Distance
2-4m
Sensor Angle
90°
Runtime
Top ＞3 H
Front Panel ＞3 H
Brightness
Top ＞50 LM
Front Panel ＞60 LM
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
GE 45255 User manual
-
-
Vaxcel T0174 Kappa LED 8-Inch Bronze Outdoor Motion Sensor Flood User manual
-
Panasonic NVRZ15B User manual
-
Sanyo VCC-XZ600P User manual
-
Samsung ECTL220ZBPUUS User manual
-
Samsung TL225 User manual
-
-
Samsung ST560 User manual
-
Sony TL220 User manual