2. Scanstrut
  3. SC120
SC120

Scanstrut SC120 User manual

  • Hello! I've reviewed the installation instructions for the Scanstrut SC120 Lifting Crane. This document outlines the steps for assembling and mounting the crane using clamps, rivets and other hardware. I'm ready to answer your questions about the installation process.
  • How many gaskets are needed for the clamp pairs?
    What is the distance between the clamp pairs when mounting?
    What size drill bit is needed for drilling holes in the pole?
Parts List Tools Required
SC120
01-06-2022 (Issue 2)
Installation Instructions
For further installation
and warranty information
please visit:
www.scanstrut.com
USA
+1 860 308 1416
[email protected]
UK & International
+44 (0)1392531280
[email protected]
1
5
6
4
2
3
Apply 4x Gaskets onto
2x Clamp pairs.
Assemble 2x Clamp pairs
onto Pole.
Assemble Ferrule Plates onto
clamp pairs using xings.
400 mm
(15.75")
Mount Clamp Pairs 400mm (17.75")
apart. Check that clamps are aligned
correctly and tighten in place.
Mark and Drill 8 x 5mm (3/16") holes
into Pole.
×
Rivet Clamps permanently
into position.
10452
3" Clamp Pair x2
10120
Lifting Crane x1
10407
Gasket x4
6005
Lifting Tackle x1
10121
Ferrule Plate x2
60068
Nut Covers x8
60702
Nylon Washer x8
x1 x4
x8 x4
2 x 10mm Spanners
ø 5mm (3/16")
Drill Bit Measuring Tool
Rivet Gun
60120
R-Clip
60621
M6 x 20mm Bolt
60665
4.8 x 16 Rivet
60060
M6 Nylock Nut
Share your installation with us.
@scanstrut
For further installation
and warranty information
please visit:
www.scanstrut.com
USA
+1 860 308 1416
[email protected]
UK & International
+44 (0)1392531280
[email protected]
SC120
01-06-2022 (Issue 2)
Installation Instructions
7 8
Assemble Lifting Crane into the
Ferrule Plates. The crane should
swing freely.
Apply nut covers.
Insert the R-Clip to secure the Lifting
Crane. Release pin for Crane stowage.
/