Subli Light Glitter

Forever Subli Light Glitter Operating instructions

  • Hello! I've reviewed the instructions for the FOREVER SUBLI-LIGHT (NO - CUT) GLITTER transfer paper. This document outlines the process for transferring designs with glitter effect onto light-colored fabrics using a heat press, including specific temperature and time settings. It also emphasizes the importance of proper washing and ironing to ensure the longevity of the print. I'm ready to assist with any questions you might have about this transfer paper.
  • What image style is recommended for this transfer paper?
    What are the recommended washing conditions?
    How long should I press the transfer paper?
PRINT SETTINGS:
Image Mode:mirrored
Print Mode:
All other sublimation printers should be used with the standard settings and standard driver .
• Image Style:Only for full-tone vector graphics. Not suitable for photographs and light colors
TRANSFER PROCESS:
Pre-heat your heat press. Make sure that the metal plate underneath the rubber mat is also hot.
• Place the textile on your lower plate and pre-press it for 5 seconds.
• Place the transfer paper onto the textile.
Press for 20-30 seconds.
Remove the transfer paper after 2 seconds.
(Never take the T-Shirt o the press before the transfer paper has been peeled off.)
For a better washability put a sheet of Matt Finish Economy or Glossy Finish with the glossy side faced down onto your
design and press again for 30 seconds with high pressure.
• Stretch the t-shirt after removing the silicone paper as long as the shirt is hot. This leads to a softer touch.
TRANSFER SETTINGS: HEAT PRESS
W ASHING:
• Up to 30°C (cold wash cycle)
IRONING :
When ironing cover the print with baking paper
IMPORTANT:
You cannot print all colors. Please make sure that you are creating and selecting your designs with
an high ink amount.
You must transfer immediately after printing (the longer the time in between printing and pressing, the less would transfer)
AUTOMATIC HEAT PRESS MANUAL HEAT PRESS
PRESSURE 3-4 bar/44-58 PSI medium-high
TEMPERATURE 170-190°C (338-374°F) 170-190°C (338-374°F)
TIME 20-30 seconds 20-30 seconds
FIXING 30 seconds (high pressure) 30 seconds (maximum pressure)
Before starting a mass production, we recommend to make transfer and washing test with all materials.
Important advice for double- sided printing on textiles:
T-Shirts for a double-sided print (frontside & backside), have to be put over the lower heat plate.
In this case only one side will be treated with heat and you avoid that the applicated design from the other
side will be pressed out again.
INSTRUCTIONS: SUBLI-LIGHT (NO - CUT) GLITTER
FOR WHITE & LIGHT COLORED COTTON, POLYESTER, NYLON & MORE
www.amayauk.com | 02392 590 281 | [email protected]
Southern Office: 400-450 Nest Business Park, Martin Road, Havant, Hampshire, PO9 5TL
Midlands Office: Unit 4A-C East Bridgford Business Park, Kneeton Road, East Bridgford, Nottingham, NG13 8PJ
1-PAPER-SYSTEM
/