2. Brainwavz
  3. Earpad Adapter Ring
Earpad Adapter Ring

Brainwavz Earpad Adapter Ring Installation guide

  • Hello! I have reviewed the Brainwavz earpad adapter ring installation guide for the Corsair Virtuoso RGB Wireless headphones. The document provides step-by-step instructions on how to replace the earpads using the adapter ring. I can help you with questions about the removal of old pads or the installation of new ones.
  • How do I remove the stock pads?
    How does the adapter ring attach?
    What should I ensure when installing the adapter?
EARPAD ADAPTER ring FOR Corsair Virtuoso RGB Wireless
Installation GUIDE
Remove Stock Pads
Grip the pad
firmly with thumbs
and fingers.
1
Twist the pad to the right
(clockwise) to release the pad
from the head unit.
NOTENOTE
: The pads are attached
to a plastic mounting ring
2
Get To Know The Adapter Ring
V
I
R
T
U
O
S
O
FRONTFRONT BACKBACK
A
There are 3 raised
clips A that fit
into corresponding
holes on each
headset
The smooth back
panel sits flat
against the inside
of your chosen
earpad.
Install The Earpads
Install The Adapter
Line up the three clips on the adapter ring A with the three
holes on the head unit B , and slot the pad into place.
Ensure all three clips are in correctly before continuing.
Grip the plastic ring and pad
together and slowly but firmly twist
10 - 15 degrees to the left (counter
clockwise).
2
1
✔
✘
AB
Slide the adapter
into the mounting
flap on the rear of
the earpad, pull the
fabric over so the
ring is completely
inside the flap
Ensure that the
fabric flap does not
obstruct any of the
mounting clips
NOTENOTE
Do not over-tighten
or you may break the
mounting clips.
/