Barclay Products 4120-60-PB Installation guide

Brand
Barclay Products
Model
4120-60-PB
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
P 847•244•1234 www.barclayproducts.com
12/4/07
1. Measure wall opening.
2. Tap I-140 insert halfway into straight rod on each end.
3. Push left bent end rod onto straight rod until both ends meet.
4. Lay connected rods on flat surface and assemble right bent end rod. As in step #3.
5. Measure rod. You can cut ends up to 1 1/2” off each end (3” total) to shorten rod. You can
increase size by sliding flange out up to 1/2” (1” total). For best results, have rods extend
into flange up to the end of the guides inside the flange.
6. When desired size is achieved, slide flanges on each end and install rod in opening.
** Do Not use set screws yet. **
7. After rod is secured to walls, use a level to make sure rod is level side to side and front to
back. Now install set screws. A 1/8” pilot hole is recommended for optimum strength.
Parts Included
• 1 Straight Center Rod • 2 Bent End Rods (end pre-plugged for flange) • 2 I-140 Plastic Inserts •
• 2 #300 Flanges • 8 Wood Screws • 2 Set Screws •
Cat. No.
4120-60 & 4120-72
Tools Needed
• Small Blade Screwdriver • Phillips Screwdriver • Level • Drill with 1/8” Bit •
• Pipe Cutter / Hacksaw •
Cellini
Shower Offset Rod
  • Page 1 1

Barclay Products 4120-60-PB Installation guide

Brand
Barclay Products
Model
4120-60-PB
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents