Endon Carlson User manual

Type
User manual

This manual is also suitable for

Carlson Plug-in Wall Light
Safety Warnings
INSTRUCTION MANUAL
• This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEEwiring
regulations.Itisforindooruseonly,andnotsuitableforabathroomlocation.
• ThisttingisaClassII,DoubleInsulatedproduct
anddoesnotrequireanEarth.LiveorNeutralmustnot
beconnectedtoEarth.
• Donotplugintothemainsuntilyourlampisfullyassembled.
• Nevertbulbsofahigherwattagethanthosespeciedonthelabel,asthesemaydamagethetting.
• Thelampmustbeprotectedbya3ampfuseinthemainsplug.
• Ifthemainscablebecomesdamageditmustonlybereplacedbyatechnicallycompetent,qualiedperson.
• Ifyouareinanydoubtaboutyourcompetencepleaseconsultaqualiedelectrician.
• Thisproductcontainsdelicateparts–takecareduringhandlingandmaintenancetoavoidbreakage.
• Ifanymodicationismadeitwillinvalidatethewarrantyandmayrendertheproductunsafe
EndonLighting,LS90SE
Assembly/ User Instructions
Before you start
Pleasereadtheseinstructionscarefullybeforettingandretainforreference.Checkthepackagingandmake
surethatyouhavealltherequiredparts.Followeachassemblystepinordertopreventincorrectassembly.
Ensurethattheproductisfullyassembledasillustratedbeforeuse.
These assembly diagrams are intended as a guide – if in doubt consult a qualied electrician.
Care Information
Allow10minutestocoolbeforereplacing,adjustingorcleaning.
Cleanwithadryclothonly.Donotuseliquidorabrasivecleanersonthisproduct.
79380_79500CarlsonW20190613
ClassIIPlugWiringDiagram
E
L
N
FUSE
Fuse
(3AMP)
Blue
(Neutral)
Brown
(Live)
The Light pack contains:
Lighttting
Fixingpack
Retainingclip.
The following tools may be required:
Selectionofcrossandatheadscrewdrivers.
Electricdrillandassorteddrillbits.
1. Donotattempttopluginorusethisproductuntilithasbeenfullyassembled.Disconnectfrommainsduring
assemblyormaintenance.
2. Decideofthepositionofthislighttting..Usethebackplate(1)asatemplatetomarkthescrewholes.
Makethescrewholesandsecuretothewallwithappropriatescrewxings(2).
3. Removethewrappingfromtheshadeandattachtheshade(3)tothelampbyremovingtheshadering(4)
fromthelampholder.Placetheshadeoverthelampholderandrettheshadering.Tightentosecurethe
shadeinplace.
4. Installthebulb(5).Donotinstallabulbwithagreaterwattageordierentshapethanspeciedonthelabel.
5. Tokeepthecabletidy,thisproductissuppliedwitharetainingclip.Decideonthecableposition.Usingthe
retainingclip(6)asatemplatemarkanddrillthepositionofthexingholes.Becarefulnottodamageany
wiringorpipes.Placethecliparoundthecableandxinplaceusingthesuppliedscrewxings(7).
IMPORTANT: Children can become entangled in loose cable. Ensure excessive loops of cable are
secured against the wall using the ttings supplied. Do not use
this product in children’s bedrooms.
6. Plugin,andoperatethelampholderswitch(8)toturnyourlampon.
If your lamp will not illuminate, please check the bulb, the 3
amp fuse in the plug and ultimately check the relevant fuse in
your Fuse Box. If unsuccessful please consult your Retailer.
79380_79500CarlsonW20190613
EndonLighting,LS90SE
Assembly/ User Instructions Continued
1
2
3
4
5
6
7
8
  • Page 1 1
  • Page 2 2

Endon Carlson User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI