The RC-LGI Interface allows easy integration of
conventional infrared repeating systems with
LG/Zenith flat panel televisions. Utilizing the IR
jack on the rear of the television, the RC-LGI
allows complete control of your system and the
television with no visible emitters that can take
away from the clean flat panel look.
Installation is as simple as plugging the included 6
foot jumper cables from the television to the RC-
LGI and from the RC-LGI to an Infrared
connector block. Connect the included power
supply and you're ready to take control!
Sensitivity can be adjusted via the trim pot located
on the side of the RC-LGI.
12 VDC
POWER
SUPPLY
EMITTERS
+12V
12VDC
GND
STATUS
EMITTERS
IR IN
TECHNOLOGY
IRB-4
DVD DOLBY DIGITAL
disc 5 2.53
tape b
WIRING DIAGRAM
12V POWER
SUPPLY
TO IR INPUT ON BACK
OF TELEVISION
TO EMITTER JACK ON
IR CONNECTING BLOCK
ADJUSTMENT POT
FOR SYSTEM FINE TUNING
OUT TO IR TARGET(S)
RC-LGI
(IRB-4 shown not included)
IN
OUT
LG/Zenith Owners...
Take Control!
Introducing the RC-LGI Infrared Interface
TECHNOLOGY
Expect Innovation!
MADE IN USA
Easily adjust the sensitivity
with the side mounted trim pot
Audioplex IRB-4 infrared
connector block shown
not included
What's included
(1) RC-LGI
(2) 6 foot jumpers (1/8" stereo plugs)
(1) 12 VDC power supply
/