Blaupunkt BVS120W User manual

Brand: Blaupunkt

Model: BVS120W

Category: Vacuum cleaners

Type: User manual

Instruction Manual

2 in 1 Cyclonic Bagless Stick Vacuum Cleaner - BVS120W

General Safety 4

Unpacking 5

Product Overview 6

How to Use 7

Conecting the Telescopic Tube to the Vaccum Cleaner Body 7

Connecting Motorised Brush to the Telescopic Tube 8

Connecting Attachment (accessories) 8

Connecting Motorised Floor Brush directly to Vacuum Body 8

Storage and Accessories Holder 9

Cleaning and Maintenance 10

FAQs 13

Speciﬁcations 14

Customer Helpline Last Page

CONTENTS

WARNING!

ELECTRICAL SAFETY AND POWER CORD HANDLING

• Voltage: Make sure that your outlet voltage and circuit frequency

correspond to the voltage stated on the power adaptor rating plate.

USAGE RESTICTIONS AND CONDITIONS

• This appliance is intended for indoor domestic use only. It is not suitable for

commercial, industrial or laboratory use.

• Do not use the appliance outdoors.

• The appliance is not intended to be operated by means of an external timer.

• The appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction on the use

of the appliance by a person responsible for their safety.

• Supervise children to ensure they do not play with the appliance. Do not allow

children to clean the vacuum cleaner or perform user maintenance.

• Maintain the vacuum cleaner in a clean condition to avoid deterioration,

which could aect its working life and result in a hazard risk.

• We accept no liability for any eventual damages due to improper use, incorrect

handling or non compliance with these instructions.

GENERAL SAFET

• To reduce the risk of electrocution and other electrical hazards, do not immerse

the cord or plug in water, do not spill liquids onto the vacuum cleaner, and do

not operate it with wet hands.

• Do not attempt to repair, disassemble, or modify the appliance.

There are no user-serviceable parts inside this unit.

Before installing your appliance, read all safety instructions in this manual,

especially the sections on electrical safety and installation.

UNPACKING

• When unpacking the product, be sure to keep all the packaging materials

until you have made sure your new product is undamaged and in good

working order. This product has been packaging to protect itself

against transportation.

• Be sure to remove all packaging materials around the product and that

the plastic film used is also removed.

• CAUTION: Plastic wrapping can be a suffocation hazard for babies and young

children. Make sure all packaging materials are out of reach for children and

that they are disposed of correctly.

PRODUCT OVERVIEW

ON/OFF

FILTER

RELEASE CAP

EXHAUST

AIR

LED LIGHT

MOTORISED BRUSH

ECO MODE

HANDLE

BATTERY RELEASE

DUST CANISTER

TELESCOPIC TUBE

RELEASE BUTTON

ACCESSORIES:

CREVICE

TOOL

BRUSH

HEAD

TELESCOPIC

TUBE

MOTORISED FLOOR

BRUSH RELEASE

BUTTON

WHEELS

SETTING UP THE VACUUM CLEANER

CONNECTING TELESCOPIC TUBE TO THE VACUUM CLEANER BODY

1. Connect the Telescopic Tube, into the Stick Vaccum Body. When

properly attached, it will Click into place.

- To release the Telescopic Tube, Press the RED button

located at the head of telescopic tube

Make sure the stick vacuum cleaner is disconnected from the charger

before assembling or removing any accessories.

HOW TO USE

WARNING!

STICK VACUUM

BODY

TELESCOPIC

TUBE

TELESCOPIC

TUBE RELEASE

BUTTON

CONNECTING MOTORISED BRUSH TO THE TELESCOPIC TUBE

1. Connect the Motorised Floor Brush, into the Telescopic Tube.

When properly attached, it will Click into place.

- To release the Floor brush, Press the RED button

located at the head of floor brush

HOW TO USE (Cont.)

CONNECTING AN ATTACHMENT

Select an attachment and plug it onto the end of the telescopic

tube or directly into the Stick Vacuum Main body.

- Make sure when connecting the attachment, that you it is

inserted corretly and the attachment held securely into place.

CONNECTING THE MOTORISED FLOOR BRUSH DIRECTLY

You can connect and plug the motorised floor brush directly

onto the Stick Vacuum Main body.

- When properly attached, it will Click into place.

TELESCOPIC

TUBE

MOTORISED

FLOOR BRUSH

RELEASE

BUTTON

HOW TO USE (Cont.)

STORAGE AND ACCESSORIES HOLDER

1. This stick vacuum cleaner comes with storage attachments.

Accessories can be held and inserted into Accessories holder.

Stick Vacuum Main body can be detached and held on below

Please refer to below image:

ACCESSORIES

HOLDER

MAIN BODY

HOLDER

MAIN BODY HOLDER

This holder can be attached by placing

it on the desired height of telescopic tube

you want to store it (recommended half

way).

Then screw into place to hold it securely.

CLEANING AND MAINTENANCE

STEP 1

Hold the Stick vacuum over a bin, as

releasing collected dust and particles

will make a mess.

STEP 2

Make sure to line up the Dust canister

up with the inside of your bin.

EMPTYING DUST CANISTER

• Always disconnect from the power adaptor before attempting to clean

any part of the vacuum or removing its contents/accessories.

• Make sure that the stick vacuum is powered OFF.

• For optimum cleaning performance, clean the filters each time you

empty the dust tank.

• Only use the vacuum with the filter intact, in dry conditions.

WARNING!

STEP 3

Press the release button located on the front

of Dust canister, this will open up the base lid of

the dust canister and drop all collected dust and

particles into the bin.

NOTE: Give the dust canister a few taps & shakes

to remove any loose dust or debris still inside the

dust canister.

CLEANING AND MAINTENANCE (CONT.)

CLEANING HEPA FILTER

1. To open the Top of Dust canister and to gain access to the

HEPA filter. Twist the top of the dust canister (stick vacuum main

body) to the right direction.

2. The Dust Canister and Vacuum will unlock and open.

3. Take out the HEPA Filter, hold it

over a bin and shake/tap to

remove the dust and debris.

NOTE: If necessary, you can rinse

the HEPA Filter with water, though

you must let it completely dry in

the sun before installing it back

into the stick vacuum cleaner.

1 2

CLEANING AND MAINTENANCE (CONT.)

CLEAN THE FLOOR BRUSH

1. Detach the floor brush by pressing the release buttons if not already.

2. Turn the floor brush upside down so you can see the brush

and locking mechanism.

3. Turn the Lock mechanism to the left to unlock

4. Lift open to OPEN the roller brush latch.

5. Hold and lift the roller up and out of the compartment.

You can now clean, remove any particles, dust or hair and then make

sure to install it correctly back into original positions.

6. Make sure at the end of the roller brush, the roller mount is

installed back into place This is what hold the roller brush

correctly into place.

C D

CLEANING AND MAINTENANCE (CONT.)

If experiencing issues with your product and isn’t operating correctly please

check the following pages for solutions to the problems. If none of the solutions

offered help solve the problem with your appliance then please contact our

call centre on info@ayonz.com.

DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.

Never use the vacuum when the suction power is very weak. When this

occurs, switch off the vaccum cleaner and unplug it. Check if the dust

canister is full. Then check if any airways is jammed with rubbish or

debris, once removed turn vacuum back on to see if operated normally.

FAQS

PROBLEM POSSIBLE SOLUTION

VACUUM IS NOT

WORKING

- Make sure it is fully charged before using, follow

the battery indication light located near the

power button.

THE VACUUM CLEANER

WILL NOT PICKUP DIRT

AND HAS LOSS OF

SUCTION

- Make sure the dust canister is installed correctly.

- The dust tank is full, if so empty its contents.

- The filters are clogged, go through cleaning and

maintenance pages (page 11) to clean out all filters

and dust.

- Make sure the accessories and attachments are

installed correct and are not blocked or cloggest

with rubbish that has been vacuumed.

DUST IS ESCAPING THE

VACUUM CLEANER

- The dust tank is full, please empty it.

- The dust tank is not installed correctly. Check to

ensure that the dust tank is clicked into place and

installed correctly.

WARNING!

SPECIFICATIONS

Ratings

DC INPUT: 27VDC 0.5A

Li-ion battery: 22.2Vdc 2200mAh (48.84Wh)

Motor Power: 120W Max.

Dust Canister Capacity: 0.8L

Operation Time: 20 Minutes - MAX MODE

35 Minutes - ECO MODE

Charge Time Up to 5 hours

Battery Yes, Rechargeable Lithium Battery

Dimensions 450 (w) x 330 (d) x 800-1000 (h) mm

Weight Net: 3.0 kg / Gross: 3.8 kg

CUSTOMER HELPLINE:

info@ayonz.com

DISTRIBUTED BY:

Ayonz Pty Ltd

Blaupunkt BVS120W User manual

Brand: Blaupunkt

Model: BVS120W

Category: Vacuum cleaners

Type: User manual

Download PDF

report

Blaupunkt BVS120W User manual

Blaupunkt BVS120W User manual

Other documents