2. Love The Drive
  3. BMW 3 convertible wind deflector 318, 323, 325, 328, M3

Love The Drive BMW 3 convertible wind deflector 318, 323, 325, 328, M3 Installation guide

  • Hello! I've reviewed the document describing the installation of the Love The Drive Wind Deflector for E36 3 Series models. This guide provides step-by-step instructions, from preparing your car to securing the deflector using black hooks and a wire bracket. I'm ready to answer any questions you might have about the installation process or the product itself.
  • Where can I find video install guides?
    What should I do before installing the wind deflector?
    What should I do after pulling out the wire hook?
We have our video install guides on
our website and on youtube.com.
Also feel free to call or email us if
you have any questions
1-855-457-5683
information@lovethedrive.com
Start by putting your top down and leaving
your lid up. Make sure the black hooks are
facing up.
Pull out the wire bracket from the closed
position.
Align the black hooks, at the rear of the
wind deflector so that they hook onto the
quarter trim panel, the area covered by the
top lid.
Making sure that both of the black hooks are
attached to the trim panel, close the top cover
lid to hold the black hooks in place.
Pull the wire bracket back and lower it so it
will line up with the hole in the trim panel.
Once the wire hook is pulled out, it will rest
on the trim panel.
If you have any questions or comments please
call 1-855-457-5683 or email [email protected]
From one side of your car, lower the wind deflector into the back seat area of your convertible.
/