2. Dahua
  3. AR506-E

Dahua AR506-E Quick Start

  • Hello! I've reviewed the Installation Quick Start Guide for the Dahua AR DH-AR506-E Enterprise Router. This document provides important details on installation, including mounting options, grounding instructions, and various cable connections. I understand that the router requires proper ventilation and grounding for safe use. I'm ready to answer any questions you have about the device.
  • What tools are required for installation?
    What should I do before connecting the power cord?
    How should I connect the grounding cable?
    What kind of air flow does router has?
OFF
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
G
G
Dahua AR DH-AR506-E Enterprise Router Installation
Quick Start-AP100 BOM: 3122A0KB
Tool list
Installation accessories
The installation tools are not provided with the router. Prepare them
yourself as required.
When working with the router, always wear an ESD wrist strap, and
make sure the strap makes good skin contact and is reliably
grounded.
Airflow of the router
• Make sure the air inlet and outlet vents of the router are not
blocked and the installation site has a good ventilation system.
• The router uses left-to-right air aisles.
Flathead
screwdriver
Phillips
screwdriver
Needle-nose
pliers
Wire-stripping
pliers
Network cable
tester
ESD
wrist strap
Diagonal
pliers
Heat
gun
Multimeter Marker
Rubber
feet
Mounting
brackets
M6
screw×4
M4
screw×4
Grounding
cable
Console
cable
Power
cord
Cable
tie
Cage nut
(user supplied)
1U
Mounting the router on a workbench
Mounting the router in a rack
Install cage nuts.
• When the router is mounted on a workbench, connect the ring
terminal end of the grounding cable to the router and the other end to
a grounding strip.
• When the router is mounted in a rack, connect the building grounding
cable to the grounding terminal on the rack to make sure the rack is
reliably grounded. Then use the grounding cable to connect the
router to the grounding terminal on the rack.
• If the installation site does not have grounding facilities but earth
ground is available, hammer an angle iron or steel tube into the earth
ground to act as a grounding conductor.
Connecting the grounding cable
Attach the mounting brackets to the router.
Mount the router in the rack.
Correctly connecting the grounding cable is crucial to lightning
protection and EMI protection. Use the grounding cable provided
with the router to ground the router.
Connecting the power cord
Connecting an Ethernet cable
Connect one end of the Ethernet cable to the target Ethernet port on
the router and the other end of the cable to the target Ethernet port
on the peer device.
Connecting the console cable
To use a console cable to connect the console port oN the router to a
PC, connect the DB9 connector of the console cable to the RS-232
port on the PC first and then connect the RJ-45 connector to the
console port on the router. If the PC does not have an RS-232 port
but a USB port, use a USB to RS-232 adapter for the USB port.
• Before connecting the power cord, make sure the router is
reliably grounded.
• To avoid bodily injury, connect the power cord to the router first
and then to the power supply system in the equipment room.
• The power cord connection in the following figure is for
illustration only.
Connecting optical fibers
Insert the transceiver module into the fiber port. Identify the RX and TX
ports of the transceiver module and use optical fibers to connect the
RX and TX ports on the local end to the TX and RX ports on the peer
end, respectively.
12
Copyright 2021, Dahua Technology Co., Ltd. All rights reserved.
/