Contents ix
Compaq Confidential – Need to Know Required
Writer: Jill Hackett Stevens / Bob Young Project: DS20E Reference Guide Comments:
Part Number: ER-K8F6W-UA. B01 File Name: a-frnt.doc Last Saved On: 10/4/99 2:40 PM
List of Figures and Examples
Figure 1–1. Rackmount and Pedestal System........................................................ 1-3
Figure 1–2. System Architecture ............................................................................ 1-4
Figure 1–3. Basic System Board............................................................................ 1-5
Figure 1-4. System Parts......................................................................................... 1-8
Figure 1-5. System Features Module.................................................................... 1-10
Figure 1-6. SFM Switches .................................................................................... 1-12
Figure 1-7. SFM Status LEDs............................................................................... 1-13
Figure 1-8. 4-slot and 6-slot Storage Subsystems................................................. 1-18
Figure 1-9. Power Supplies................................................................................... 1-19
Figure 1-10. Combination Module........................................................................ 1-20
Figure 1-11. Operator Control Panel (OCP)......................................................... 1-21
Figure 1-12. Diagnostic LEDs.............................................................................. 1-23
Figure 1-13. Rear Panel ........................................................................................ 1-24
Figure 1-14. Hard Disk Drive Status LED Location............................................. 1-26
Figure 1-15. Removable Media Bay and Combination Drive............................... 1-28
Figure 1-16. Console Terminal Connections........................................................ 1-30
Figure 2-1. System Dimensions and Service Area.................................................. 2-2
Figure 2-2. Power Supply Requirements................................................................ 2-3
Figure 2-3. Unpacking a System............................................................................. 2-4
Figure 2-4. System Cable Connections................................................................... 2-5
Figure 2-5. System Lock and Key .......................................................................... 2-7
Figure 3-1. Rackmount Server Shipment Box........................................................ 3-2
Figure 3-2. Power Supply Connections .................................................................. 3-3
Figure 3-3. Rackmount Installation Area................................................................ 3-4
Figure 3-4. Preparing the Rackmount System ........................................................ 3-5
Figure 3-5. Installing Chassis Slides (Rittal VR Rack)........................................... 3-6
Figure 3-6. Installing the System............................................................................ 3-7
Figure 3-7. Installing the Cable Management Bracket ........................................... 3-9
Figure 3-8. Cable Loop at the Rear of the System................................................ 3-10
Figure 3-9. M-series Rack Accessories.................................................................. 3-12
Figure 3-10. Attaching Mounting Brackets and Slides......................................... 3-14
Figure 3-11 Attaching Slide Brackets to Slides..................................................... 3-16
Figure 3-12. Attaching Slide Brackets................................................................... 3-18
Figure 3-13. Activating the Stabilizer Foot........................................................... 3-20
Figure 3-14. Installing the System into the M-series Rack................................... 3-21
Figure 3-15. Attaching the System to the Rack .................................................... 3-22
Figure 3-16. Installing the Interlock System.......................................................... 3-23
Figure 3-17. Installing the Cable Management Arm............................................. 3-25
Figure 3-18. Dressing the Cables........................................................................... 3-26
Figure 3-19. Attaching the Front Bezel................................................................. 3-27
Example 4-1 booting UNIX from a Local SCSI Disk. ........................................... 4-9
Example 4-2 RIS Boot.......................................................................................... 4-11
Example 4-3 Text-Based Installation Display ...................................................... 4-13
Example 4-4 Booting OpenVMS from the Local CD-ROM Drive. ..................... 4-15
Example 4-5 InfoServer Boot............................................................................... 4-17