iAMP-GM1
Camaro Power Seat Fix
Corporate
Headquarters
13190 56th court
Clearwater, FL 33760
800-488-2267
727-573-9326 (Fax)
Technical Support
West Coast
Operations
1340 Ritchey Street
Santa Ana, CA 92705
800-854-3133
714-835-3233 (Fax)
Technical Support 866-931-8021
T.T.
EH
It has come to our attention that the iAMP-GM1 may reset when adjusting the power seats in the Camaro.
Please follow the steps below to remedy the issue.
1. Locate the 5-pin plug at the amplifier
and disconnect it.
2. Locate the black wire in Pin 1
of the 5-pin plug.
3. Flip the plug over and remove this
wire by pressing on the release tab
with a straight pick or similar tool.
4. The plug should look like this
when finished. Secure the wire
with electrical tape and re-connect
to the amplifier.
Please Note: If updating the firmware on the iAMP LCD touch screen display becomes
necessary, you will either have to re-connect this wire or remove the radio to gain access
to the display harness.
012412