Chicago Electric 62486 Quick start guide

Chicago Electric
Brand
Chicago Electric
Model
62486
Type
Quick start guide

This manual is also suitable for

WARNING
To prevent serious injury, read manual warnings and instructions before use.
62486 TIG WELDING
QUICK START GUIDE
Turn gas
ON and
set flow.
8
BASIC WELDING INSTRUCTIONS AND WELDING TIPS ARE IN MANUAL.
1
Sharpen Tungsten Electrode.
3
Attach gas hose and
regulator/flow meter
(sold separately).
Connect Argon gas.
4
Attach Ground Clamp.
Secure Clamp to
exposed metal part of
weldpiece or worktable.
5
Attach TIG Torch to
Welder.
WARNING
To prevent re and
serious injury:
Keep torch clear
of grounded
objects while
welder plugged in.
Grinding
Wheel
Electrode
2
Assemble Torch. Match Collet and Collet Body
sizes to Electrode. Match Gas Nozzle to
shielding gas requirements in Settings chart.
HOLD TORCH
CLEAR
TIG Torch
Grounding Clamp
Grounding Clamp
Optional: Attach Foot Pedal.
Gas Inlet
(5/8"-18)
Move TIG/Stick Switch to
“TIG”. Set gas post flow delay
and intended current output.
6
Hold Torch clear of weldpiece.
Plug in Welder and turn ON.
7
A
LONG
9S
2S
SHORT
165 A
INVERTER TIG/STICK
WELDER
with High Frequency Start
ON
OFF
A
OUTPUT
ITEM 62486
A
LONG
10S
2S
SHORT
165 A
INVERTER TIG/STICK
WELDER
with High Frequency Start
ON
OFF
A
OUTPUT
ITEM 62486
Gas Post Flow
Delay Switch
TIG/Stick Switch
Current
Output Knob
Gas
Nozzle
Collet
Collet
Body
Insert tungsten Electrode here.
Good
Weld
Weld Speed
Too Fast
TO CORRECT:
weld
slower
Weld Speed
Too Slow
TO CORRECT:
weld
faster
CLEANSE WELD-PIECE OF CONTAMINANTS
BEFORE BEGINNING TO WELD!
62486 STICK WELD EXAMPLE PICTURES
A
LONG
9S
2S
SHORT
165 A
INVERTER TIG/STICK
WELDER
with High Frequency Start
ON
OFF
A
OUTPUT
ITEM 62486
Current
Too Low
TO CORRECT:
Increase
Current
A
LONG
9S
2S
SHORT
165 A
INVERTER TIG/STICK
WELDER
with High Frequency Start
ON
OFF
A
OUTPUT
ITEM 62486
Current
Too High
TO CORRECT:
Decrease
Current
Stick Welding
1. Attach Ground
Clamp. Secure
Clamp to exposed
metal part of
weldpiece or
worktable.
2. Attach Stick
Clamp to Welder.
3. Move TIG/
Stick Switch to
“Stick”.
4. Hold Stick
Clamp clear of
weldpiece. Plug
in Welder and
turn ON.
Arc Length
Too Short
TO CORRECT:
Arc Length
Too Long
TO CORRECT:
TIG welding is
a complicated
process, requiring
experience and
skill to achieve
successful results.
Training beyond
the scope of this
guide is required to
TIG weld properly.
  • Page 1 1
  • Page 2 2

Chicago Electric 62486 Quick start guide

Chicago Electric
Brand
Chicago Electric
Model
62486
Type
Quick start guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents