Camel Toe MkII
instruction manual
WHE-209
SPECIFICATIONS
RHINO
INPUT IMPEDANCE.........> 400 kΩ
OUTPUT IMPEDANCE.......< 100 Ω
NOISE FLOOR...................
-
98 dBV
NOISE FLOOR
(
Classic
)...
-
100 dBV
BYPASS................................................................……..Relay True Bypass
DIMENSIONS......................................................4-25/32" x 3-3/16" x 1-3/4"
WEIGHT..................................................................………...................13oz
CURRENT DRAW.............................................................................110 mA
ENGAGED........................................................................................110 mA
BYPASSED......................................................................................22.8 mA
POWER SUPPLY......................................................................... 9 volts DC
All measurements made with controls at center.
Noise measurements are A-weighted.
POWER
The Camel Toe
™
Overdrive MkII is powered by a single 9-volt battery,
a 9-volt AC adapter such as the Dunlop ECB003/ECB003EU, or the
DC Brick
™
and Iso-Brick
™
power supplies. The power input is a
5.5mm x 2.1mm jack with the positive voltage on the outer sleeve.
Using an external power supply will disconnect the battery.
Disconnect the input jack to preserve battery life when not in use.
The pedal will lock into bypass mode when it is time to change the
bat ter y. It also includes power protection circuitr y to prevent
damage from AC power supplies.
92503020548REVA
LLAMA
INPUT IMPEDANCE............100 kΩ
OUTPUT IMPEDANCE...….< 10 kΩ
NOISE FLOOR....…........…-85 dBV
TONE
DRIVE SELECT BYPASS
HI CUT
TRIPLE OVERDRIVE MKII
series
classic
RHINO LLAMA
VOLUME
DRIVE
VOLUME
DRIVE
OUT IN
+9VDC
Way Huge devotees rejoice! The legendary Camel Toe
Triple Overdrive is back to expectorate its wonderfully
wild gritty tones all over your guitar signal. The Mark II
herds the Green Rhino Overdrive and the Red Llama
Overdrive tog ether i n to a si n gle rowd y s t a b le of a
stompbox. The Green Rhino section has all the controls
of its Mark IV iteration, while the Red Llama section gets
an all-new Hi-Cut control to go with Volume and Drive.
Use the Drive Selector footswitch to toggle between the
two circuits, or flip the Series switch for a whole ’nother
sound: the G reen Rhino OD a nd the Red Llama OD
combined in series. In Series mode, the Drive Selector
switch toggles the Red Llama OD on/off while the Green
Rhino OD is always active. The Camel Toe Triple Overdrive
MkII is an untamed beast! Handle with caution.
FOOTSWITCH - toggles
the effect on
/
bypass (blue LED
indicates effect is ON)
100Hz -
Governs the
amount of
thump in your
Rhino stomp,
+/
– 12dB
UNBRIDLED
OVERDRIVE!
CLASSIC -
toggles classic
green rhino sound
on/off (up=on, makes
100hz & 500hz
controls inactive)
VOL UME - Regulates the
roar of the Rhino
DRI VE - A DJUS TS
YOUR RHINO'S
HA IR INES S
500Hz - ADJUSTS
THICKNESS OF YOUR LOWER
MID–SECTION, +/– 12DB
TONE -
Modifies the tone
from mellow
to bright
dri ve – UNLEASHES GNARLY,
THUNDEROUS GRIT
volume –
CONTROLS THE LEVEL OF AMP-
DOMINATING OUTPUT
S ER IES -
CRASHES RHINO CIRCUIT
INTO LLAMA CIRCUIT
Hi CUT -
CUTS HIGH
FREQUENCIES
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Way Huge Red Llama WHE-206 User manual
-
Infinity Power Camel Instruciton Manual
-
Mangar Camel Quick start guide
-
Enabling Devices 9348 User manual
-
Enabling Devices 8025 User manual
-
Pinnacle Speakers Rhino-Fiftenn User manual
-
Cadence subwoofer User manual
-
Educational Insights Zookeeper's Nightmare Product Instructions
-
Winncare MANGAR User manual
-
