auto tuning (ATV and DTV signals).
(For more details see"Customising the CHANNEL settings", page 16 of User Manual.)
“DTV”, “ATV”, "AV", "PC", "YPbPr", "Blu-ray", "HDMI1",
CH
+/-
+/-
+/-
+
-
10
1. Connect a USB/Hard Disk Drive (HDD) into USB1 at the side panel as shown by the picture below
2. After USB/HDD is connected, you will need to format it before doing any recording.
3. Follow instructions below to enter DVR menu to format USB / HDD:
Press menu button on the remote control.
Select CHANNEL tab and press enter.
Scroll down and select DVR File System.
Select Start to format USB / HDD.
4. Once formatting is done, you can press button to record.
The progress bar will be displayed.
A. Connect your antenna to the RF port. Connect the power plug to the TV.
B. Plug your TV (and any other connected devices) into the wall power outlet. Turn on the wall power outlet.
C. The TV should now be in Standby Mode with the LED indicator lighted up in red. Press the POWER
button on the TV or remote control to turn it on. The LED light will switch to green when the TV is on.
Recording
nacS otuA VTno hctiwS
USB Media Playback
5. Press the STOP button to stop recording.
6. Press REC list button on your remote to view your record while watching a desired programme.
A Connect a USB/Hard Disk Drive (HDD) at the side panel of the unit.
B Press USB button on the remote control.
(For more details, refer to "Multimedia Operation", page 26-29 of User Manual.)
(For more details, refer to “Recording Operation” , page 21-25 of User Manual)
"HDMI2", "HDMI3", "USB".
WARNING: Formatting an external drive would erase all memory in the system. Please make sure
that no important documents are stored in the external drive before formatting. TEAC is not
responsible for any loss of data.
TEAC CUSTOMER SUPPORT HOTLINE (TCS)
1300 553 315
Between Monday to Friday – AEST 8AM to PM
→
AC POWER IN
1Hr.
PC-IN
3
Connect a USB/Hard Disk Drive
