Page is loading ...
Wireless Router RNX-N4PS
Trouble Shooting
Wireless Router Trouble Shoo ti ng
1
How do I configure my RNX-N4PS as a Repeater?
Repeater Mode uses WDS (Wireless Distribution System).
This Repeater mode will help to extend your current Wireless Router’s signal range
through appears to bridge and accept wireless clients at the same time (unlike
traditional bridging). It should be noted, however, that throughput in this method is
halved for all clients connected wirelessly.
Please follow below steps to set up RNX-N4PS as a Repeater.
1) Link the Cable between your computer and RNX-N4PS’s LAN port.
2) Open your web browser and type the IP address of the RNX-N4PS which you want
to use as the repeater. The default IP address is 192.168.0.1. At the login, enter your
username and password (default username: admin, password: admin).
3) Through ‘‘Wizard’’ selection, you can select to set this RNX-N4PS to run at AP
Repeater Mode.
Wireless Router Trouble Shoo ti ng
2
4) The Wizard will prompt you to enter the SSID which you want to use for this
Repeater. Key-in your desire SSID, then click ‘‘Next’’
You should see the below page, click ‘‘Reboot’’
You will see the count down of the system rebooting
5) The router will restart and set as a repeater now.
6) As repeater, RNX-N4PS’s DHCP function will be disabled. So you will need to
manually set your computer’s IP in order to login to the management page.
Windows XP:
Step 1 Click on Start > Control Panel > Network and Internet Connections >
Network connections.
Step 2 Right-click on the Local Area Connection which represents your network
card and select Properties.
Wireless Router Trouble Shoo ti ng
3
Highlight Internet Protocol (TCP/IP) and click Properties.
Click Use the following IP address and enter an IP address that is on the same
subnet as the LAN IP address on your router. Example: If the router’s LAN IP
address is 192.168.0.1, make your IP address 192.168.0.X where X is a number
between 100 and 200. Make sure that the number you choose is not in use on the
network.
Set Default Gateway the same as the LAN IP address of your router (192.168.0.1).
7) Open your web browser and type in 192.168.0.1 on the address bar. At the login,
enter your username and password (default username: admin, password: admin).
8) You will see the configuration homepage under ‘‘REPEATER’’ mode now.
9) Click ‘‘Wireless’’, then in ‘‘Basic’’, Click ‘‘Site Survey’’
Wireless Router Trouble Shoo ti ng
4
10) After click ‘‘Site Survey’’, you will see a popup window like below. Click Refresh to
find your Wireless Router’s SSID.
Click ‘‘Select’’ to add your desired network.
11) Upon adding, you will see the below page. Please type in your Wireless Router’s
Connecting Encryption method and Password. Then Click ‘‘Apply’’
Wireless Router Trouble Shoo ti ng
5
12) You should see the system is counting down.
13) When finish, you should see this shows up. Click ‘‘Close’’
14) Your RNX-N4PS is now ready to act as a repeater to help you extend your wireless
broadcast range!!
/