2. Renson
  3. Pyramid 5000

Renson Pyramid 5000 User manual

  • I have reviewed the instructions for the 5000 EA Series Slotvent. The document outlines the steps for proper installation, ensuring the vent and canopy are positioned correctly. It also provides specific measurements for slot height and placement. I am prepared to answer your questions about the product described.
  • What is the tolerance for the slot height?
    What should I do after mounting the vent and canopy?
    What are the steps for preparing the vent for use?
5000 EA Series Slotvent
Position vent Slot sizes
slot height H position X below
centerline
position Y above
centerline bridge slot width R
13 mm* X = 3 mm Y = 2 mm
10 mm
2 x 165 mm
14 mm* X = 2 mm Y = 1 mm 2 x 163 mm
15 mm* X = 1 mm Y = 1 mm 2 x 160 mm
16 mm* X = centerline Y = centerline 2 x 148 mm
* tolerances slot height (-0/+0.5)
Ensure Canopy & Vent are correctly positioned according to the instructions, to ensure the slot is not obstructed
in any way that will impede air flow.
If there are any questions regarding the fitting of this vent, please contact your local distributor.
➀ mill the routing as described
➁ open the plastic flaps, mount the
vent in closed position
➂ open the plastic flaps and mount
the canopy
➃ drill pilot hole and mount with
included screws
➄ close all 4 plastic flaps
➅ ready to use: open the vent!
X
Section
Vent
Canopy
03/18 L8000005
364
R
Position Canopy
Position Vent
Vent
Canopy
plastic flap
plastic flap
aluminium powdercoating
R
10mm
Defined by tool
Defined by tool
10mm
372
H
H
“Pilot hole” 2 mm
“Pilot hole” 2 mm
“Pilot hole” 2 mm
“Pilot hole” 2 mm
/