2. VEVOR
  3. B07D7NNKNH
B07D7NNKNH

VEVOR B07D7NNKNH User manual

  • Hello! I've reviewed the user manual for the badge maker. It covers the assembly process, including attaching the base and handle, and the badge creation process. I’m ready to help you with any questions about the instructions or specific parts of the machine.
  • What is the first step in assembling the badge maker?
    What should be placed in the left die?
    What should be placed in the right die?
BADGE MAKER
ASSEMBLY
APPLICATION
At first, remove the base plate
from packaging and then screw body
to it with a bolt and a washer.
Place metal badge top (rim down) in
left hand die in the circular slot.
Cover with cut out print (printed
side up) and one plastic film.
Press down the handle to complete
assembly. Be sure there will be some
gap in the top die when you press down
the handle.
Align die set into the body groove.
The top die may need to be lifted
before sliding die set.
×
Place pinned back (zigzag side of pin
showing) in right hand die. Press down the
handle to complete assembly. There must be
no gap in the top die when you press down
the handle.
Secure die set with two small nails.
Screw the handle to the body.
When cutting out your prints using the rotary
cutter, ensure that you cut out on a suitable
surface such
as perspex, nylon
or
polypropylene. Any other surface used may
damage the blade on the cutter.
/