3
IMPORTANT! Follow exactly the instructions given and check the pictures. Keep your hands from
entrapment!
IMPORTANT! AFTER EACH OPERATION, MAKE SURE THAT YOU HAVE FOLLOWED THE
INSTRUCTIONS CORRECTLY AND THE FIXING IS STABLE!
IMPORTANT! Tighten the screws well, without overtightening them. If screws are loose, this could
lead to disassembly of some part and injure to the child!
ASSEMBLY INSTRUCTIONS
Necessary tools: wrench (not included).
№ PART DESCRIPTION № PART DESCRIPTION
1. Frame 9. Parking device
2. Handlebar 10. Rear storage basket
3. Push handle 11. Rear wheels axles
4. Seat 12. Front storage basket
5. Rear wheels 13. Cup/bottle holder
6. Guiding rod 14. Canopy
7. Mud guard 15. Cover caps
8. Front wheel with fork
ASSEMBLY
1. INSTALLING THE MUD GUARD TO THE FORK TUBE
2. INSTALLING THE FORK (WITH FRONT WHEEL AND MUD GUARD) TO THE FRAME TUBE
3. INSTALLING THE GUIDING ROD
3-1 – Insert the hook at the end in the corresponding hole in the mud guard.
3-2–Attachtheotherendoftheguidingrodtotheplateinthelowerendofthepushhandleandxit
with screws and washers.
4. INSTALLING THE handlebar
4-1 – Put the handlebar to the fork tube.
4-2–Pressthepinandinsert,untilyouhearandclickandhandlebarisxed.Coverthecapandtighten
the screw.
5. INSTALLING THE FRONT STORAGE BASKET
6. INSTALLING THE PARKING DEVICE
Aligntheprotrudingpartoftheparkingdevicewiththegrooveintheframeandxit.
7. INSTALLING THE REAR WHEELS
7-1 – Put the rear wheels on the rear axles. Install the rear axles to the frame until you hear a click and
theyarexed.
7-2 –Put the cover caps on the two rear wheels.
8. INSTALLING THE REAR STORAGE BASKET
Puttherearstoragebasketontheframeandxitwiththescrewwithplastichead.
9. INSTALLING THE SEAT
9-1 – Place the seat base on the frame.
9-2–Placetheseatontheseatbaseandxitwithwasheronbottompartoftheframe.
10. INSTALLING THE CANOPY
Press the pin on one of the tubes and insert it in the seat.
To remove the canopy, press the left button on back of the backrest (under the upholstery) and pull out
the canopy.
11. INSTALLING THE PUSH HANDLE
Press the pin and insert the handle in the corresponding opening on back of the frame until you hear a
click and the pin goes through the opening.