Impress 98586201M User manual

READ AND SAVE THIS USE AND CARE BOOK

CONSERVER CE GUIDE D’ENTRETIEN ET D’UTILISATION

POR FAVOR LEA ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO

MODEL NO. IM-709V

®

9-INCH DIAMETER HIGH-VELOCITY FAN

VENTILATEUR À HAUTE VÉLOCITÉ DE 9 POUCES

VENTILADOR DE ALTA VELOCIDAD DE 9 PULGADAS DE DIÁMETRO

SAFETY PRECAUTIONS

WARNING

POLARIZED PLUG

This appliance has a polarized plug (one blade is wider than the othe

r.) As a safety feature,

this plug ﬁts in a polarized outlet only one wa

y. If the plug does not ﬁt into the outlet,

reverse the plug and try again. If it still does not ﬁt, contact a qualiﬁed electrician. Do not

attempt to defeat this safety feature.

ELECTRICAL CORD

The cord of this appliance was selected to reduce the possibility of tan

gling in or tripping

over a longer cord. If more length is needed, use an extension cord ra

ted no less than 15

amperes.

When using an extension cord, do not let it drape over the working area or dangle

where someone could accidentally trip over it. Handle cord carefully

for longer life; avoid

jerking or straining it at outlet and appliance connections.

2 English

Be sure to shut off electric supply at main switch

or circuit breaker before installation.

The impor-

tant safeguards and instructions on this manual

are not meant to cover all possible conditions

and situation that may occur. It must be under-

stood that common sense, caution and care are

factors which cannot be built into any product.

These factors must be supplied by the person(s)

caring for and operating the unit.

No responsibility will be accepted for any dam

-

age which may occur during transport or by

improper installation or voltage fluctuation or

if any portion of the porduct has been altered or

modified.

1. Never insert fingers or any other objects

through the grille guard when fan is in opera

-

tion.

2. Disconnect the fan when moving from one

location to anothe

r.

3.

Disconnect the fan when removing guards for

cleaning.

4. Be sure fan is on a stable, flat surface when in

operation.

5.

Do not use fan on a window. Rain and mois-

ture causes electrical hazards.

6.

To reduce the risk of fire or electrical shock,

do not use this fan with any solid-state speed

control device. (ex. clapper)

7. For indoor use onl

y.

POWER CORD SAFETY TIPS

1. Never pull or yank on the cord or the appli-

ance.

2. To insert plug, grasp it firmly and guide it into

the power outlet.

3.

To disconnect appliance, grasp plug and

remove it from the power outlet.

8.

This product employs overload protection

(fuse). A blown fuse indicates an overload

or short-circuit situation. If the fuse blows,

unplug the product from the outlet. Replace

the fuse (see How

To Replace Fuse for

instructions) following the product markings

for proper fuse rating. Check the product. If

replacement fuse blows, a short-circuit may be

present and the product should be discarded or

returned to an authorized service facility for

examination and/or repai

r.

9.

Do not run cord under carpeting. Do not cover

cord with throw rugs, runners or similar cov

-

erings.

Do not route cord under furniture or

appliance.

Arrange cord away from traffic area

and where it will not be tripped ove

r.

DO NOT OPERATE APPLIANCE IF THE

POWER CORD SHOWS

ANY DAMAGE,

OR

WORKS INTERMITTENTLY AND

STOPS WORKING.

10. To maintain operating efficiently, user

should not operate the product 24 hours a

day, seven days a week.

English 3

SAVE THESE

INSTRUCTIONS

FOR HOUSEHOLD

USE ONLY

HOW TO USE

• Make sure plug fits tightly into outlet. 120

volts 60 hertz,

A.C. current. A loose fit will

cause overheating and permanent damage

to the plug.

• Turn fan switch to desired level: Low,

Medium or High.

•

To turn off fan, use the switch and turn to

Off.

•

Always operate fan on its base in the nor-

mal position with both legs on the floo

r.

CARE & CLEANING

• This fan should be cleaned on an as needed

basis to prevent restricted air flow of both

grilles and moto

r.

• Before cleaning the fan, unplug the power

cord from outlet.

• Remove front grille by removing screws

on the sides (

DO NOT REMOVE REAR

GRILLE).

• Clean grilles and blade with damp cloth.

Avoid harsh chemical cleaners as these amy

ruin the fan finish.

• Do not immerse the motor in water.

• Re-attach front grille.

• Remove excess dust from the motor vents

with a vacuum cleane

r.

•

Your fan motor is permanently lubricated

and requires no additional oil.

•

Allow fan to dry completely before use.

Tab

1.

2.

3.

4. Before each use, inspect the power cord

forcuts and/or abrasion marks. If any are

found, this indicates that the appliance should

be serviced and the power cord replaced.

Please return it to the manufacturer for service

or to an authorized service representative.

5. Never wrap the cord tightly around the

appliance as this could cause the appliance to

fray and break.

6. Do not replace attachement plug.

This

contains safety device (fuse) that should not

be removed, Discard product if the attachment

plug is damaged.

IMPO

RTANT: During the first few minutes of

initial use, a slight odor may be noticeable. This

is normal and will quickly disappea

r.

CAUTION: Do not alter the fan

’s assembly.

HOW TO REPLACE FUSE

WARNING: Risk of fire. Do not replace

attachment plug. Contains a safety device (fuse)

that should not be removed. Discard product if

the attachment plug is damaged.

1. Open fuse cover - slide open fuse access cover

on top of attachment plug towards blade.

2. Remove fuse carefully - turn fuse holder over

to remove fuse.

3. Close fuse cover - slide close the fuse access

cover on top of attachment plug.

WARNING! Risk of fire. Replace fuse only

with2.5

Amp, 125 Volt fuse.

WARRANTY

Length of Warranty

1 year from date of purchase

Within 1 year from date of purchase,

1) Return product to place of purchase

(if your dealer allows)

OR

2) Send product postage pre-paid to:

I.E.A.C.

3030 East Vernon Avenue

Vernon, California, USA 90058

Please include original dated receipt,

explanation of defect and return name

and address as well as a contact phone

number.

We will, within 10 days of receiving

your product, return a new or refur-

bished (at our discretion) product at NO

ADDITIONAL CHARGE.

We will also return your receipt. If prod-

uct is found to be in working condition,

we will return product postage collect.

PACK YOUR PRODUCT WELL!

We will not be responsible for damages

incurred as a result of improper packing.

4 English

Page is loading ...

Impress 98586201M User manual

Impress 98586201M User manual

in other languages

Related papers

Other documents