Badger Basket EMBASSY 00934 Assembly Instructions Manual

3.0/0517/TG

MODEL NUMBERS*:

EMBASSY™ HIGH CHAIR

00933 - Natural

00934 - Cherry

00936 - Espresso

Assembly Instructions. Adult Assembly Required.

Read all instructions before use.

This manual is part of the product and

must be kept for future reference.

VERSION CODE*:

3.0/0517/TG

* Model and Version numbers are needed

if replacement parts are requested

Badger Basket, PO Box 227, Edgar, WI 54426-0227 USA • Web: www.badgerbasket.com

U.S. Based Customer Service Toll-Free (Mon-Thurs 7:00 AM-4:00 PM CST): 1-800-236-1310

Phone: 715-352-2311 • Fax: 715-352-3163

FOR REPLACEMENT PARTS:

http://www.badgerbasket.com/parts

3.0/0517/TG

/!\ Read all instructions before beginning /!\

CARE AND CLEANING INSTRUCTIONS:

Wipe with a damp cloth after each use; dry thoroughly to prevent water

from damaging the wood surfaces. Do not use detergent or soap on the

wood parts. Plastic insert tray is dishwasher safe (do not put wood tray

in dishwasher). To protect the color/nish, do not expose the chair to

bright sun for long periods of time.

Seat Cushion Cover can be machine washed in cold

water, gentle cycle, do not bleach, do not iron; air dry for longer life,

or tumble dry low or no heat.

Seat cushion can be wiped clean with a damp cloth.

BEFORE YOU BEGIN ASSEMBLY:

Check all parts and hardware. If anything is missing or not

satisfactory, please DO NOT call the store or return the

product to them. Please go online to

http://www.badgerbasket.com/parts

for assistance. Most problems are resolved promptly

without you needing to leave home. When contacting us, please

have this instruction manual, your product model

number, and your product version code ready.

Your Product Model Number: See Cover Page

Your Product Version Code is: 3.0/0517/TG

3.0/0517/TG

• READ ALL INSTRUCTIONS before use of this product. Keep instructions for future use.

• Use only the parts and hardware provided by Badger Basket.

• Do not use the product if it is damaged, broken, torn, or missing parts.

• Hardware may include small parts. Choking Hazard! Keep unassembled parts out of the reach of

small children.

• No product is a replacement for adult supervision.

• DO NOT allow anyone to climb, stand on, or play on or inside of this product.

It is not a step stool or ladder.

• It is recommended that the high chair be used only by children capable of sitting

upright unassisted. This is usually around six (6) months of age.

• The TRAY and FRONT BAR are only for use in the TOP seating position.

• NEVER use the TRAY without the CURVED FRONT RAIL.

• NEVER use the chair without the CURVED BACK PIECE.

• PREVENT SERIOUS INJURY OR DEATH FROM FALLS OR SLIDING OUT.

• Your child MUST ALWAYS be secured with the 5-point seat harness regardless of

child’s age and position of the seat until the child is approximately 3 years old.

• The tray is not designed to hold the child in the chair.

• ALWAYS keep your child in view while in the chair.

• NEVER leave your child unattended, not even for “just a minute”.

• ALWAYS ensure the chair is on a at, level surface.

• BE AWARE of what items are in the area around the chair that your child can reach, grab, or

pull that could be a choking, electrical, strangulation, injury, or other type of hazard.

• DO NOT make adjustments to the seat height while child is in the chair.

• Once the chair is assembled and all the bolts are tightened, the seat and footrest

platforms SHOULD NOT HAVE ANY MOVEMENT front to back or side-to-side.

• If your seat and/or footrest is NOT FIRMLY HELD IN POSITION, DO NOT USE THE CHAIR until

you have contacted Badger Basket Co. for assistance.

• Check the t of the 5-Point Harness regularly and ensure it’s tted properly and comfortably.

• Keep the harness buckled and out of reach when not in use. Loose, dangling straps

may be an entanglement and/or strangulation hazard.

• NEVER place the chair near re or open ame nor other sources of intense heat.

• Chair can be used for children and adults weighing up to 175 pounds/79.5 kg.

• Chair is compliant with ASTM F404 safety standards.

WARNING! FAILURE TO FOLLOW THESE

WARNINGS AND THE INSTRUCTIONS MAY

RESULT IN SERIOUS INJURY OR DEATH.

NEVER LEAVE CHILD UNATTENDED.

3.0/0517/TG

NOTICE!

Proper maintenance of your Embassy™ chair will ensure

years of use and enjoyment. Retain these instructions and

review and follow them regularly.

Check and retighten all hardware 1-2 weeks after initial assembly. Thereafter, check to make sure all the

hardware remains tight at least on a monthly basis.

Loosen the hardware before adjusting height/position of the seat and footrest panels, or when you add/remove the

front bar or wood tray, to ensure you don’t damage the parts or wood nish. Be sure to retighten the hardware securely

after any adjustments.

Also, please level the chair when assembling for the rst time and when making any adjustments. Level the chair

by standing it up on a at, level oor/surface when the hardware is still slightly loose, and then tighten all the hardware

securely.

After initial assembly, keep the ALLEN WRENCH in a safe place!

Please note that if your table has a wide apron under the

table top it makes it easier for your child to push his/her

legs against the table and tilt backwards. For this reason,

you must ALWAYS use the Glide Extenders included with

the chair and ALWAYS supervise your child while in the

chair.

To prevent instability when your child is climbing in and

out of the chair, the front edge of the Foot Rest Platform

should NEVER stick out past the front edge of the chair

legs at oor level.

The Embassy™ chair is designed to

slide on the oor and remain in an

upright position, assuming a proper

oor surface is used. Always use the

Embassy™ High Chair on a level,

stable, hard oor surface that doesn’t

prevent it from gliding backwards. Soft

surfaces, such as rugs, carpets, and

foam padding or any surface the chair

can sink into, are not safe nor suitable

for the Embassy™ chair. Any uneven

surface, such as tiled oors, is also

unsuitable. The chair and glide extend-

ers and the oor must always be kept

clean.

3.0/0517/TG

PROPER USE OF THE 5 POINT SEAT HARNESS:

SEE FIGURE A (BELOW) - YOUR MODEL OF CHAIR MAY VARY FROM SHOWN BUT SEAT HARNESS

WORKS THE SAME WAY:

When your child is sitting in the high chair, the shoulder straps (3) come up BEHIND the chair and OVER THE

TOP OF the CURVED BACK PIECE and then down over the child’s shoulders to hook to the harness buckle

in front.

The waist straps (4) go around the child’s waist and snap into the harness buckle in front, and the crotch strap

(5) will rest beneath the child and between the legs.

IMPORTANT: It is essential that you install the TRAY WITH THE CROTCH RESTRAINT BELT per the

instructions and do not leave them out when you are using the seat platform in the top position! See

STEP 3 of assembly.

FIGURE B - The Embassy™ Chair can be used for infant through adult!

FIGURE A

Parts list

A B C D E F

1x Left Side 1x Right Side 1x Bottom Rail 1x Curved Back Piece 1x Wood Tray 1x Curved Front Rail

G H I J K L

1x Seat Platform 1x Foot Rest 1x Seat Cushion 1x 5 Point Seat Harness 2x Connecting 1x Plastic Tray

M N O P Q R

1x Allen Wrench 4x Long Bolts 4x Medium Bolts 2x Small Bolts 4x Large Barrel 2x Small Barrel

M6x 50mm M6x 40mm M5x 40mm M6x 12mm M5x 9mm

Save this wrench for

future use!

1x Seat Cushion

See STEP 2 for information.

T U V W

4x Glide Extenders 8x Short Bolts 8x Washer 8x Spring Washer

Platform

Rods

Nuts Nuts

Cover

1

IMPORTANT: DO NOT TIGHTEN THE BOLTS UNTIL THE CHAIR IS FULLY

ASSEMBLED or you will not be able to insert the Seat and Footrest Platforms

and the Tray.

PLEASE ASSEMBLE THE CHAIR ON A CARPETED SURFACE OR ON TOP

OF THE BOX IT CAME IN TO PREVENT SCRATCHES OR DAMAGE DURING

ASSEMBLY.

M N O Q T U V W

1x Allen Wrench 4xLong Bolts 2xMedium Bolts 4xLarge Barrel Nuts 4xGlide Extenders 8xShort Bolts 6xWasher 6xSpring Washer

M6 x 50mm M6 x 40mm M6 x 12mm

TOOL

A

B

C

K

T

Q

U

N

O

V

W

N

D

F

Q

U

V

W

N

V

W

N

V

W

V

W

O

V

W

U

T

U

T

3

2

The 5 POINT SEAT HARNESS is pre-attached to

the SEAT PLATFORM.

It is not shown in the diagrams because no

assembly is needed.

P

E

G

H

R

P

1. The FOOT REST PLATFORM must be

inserted into the slot at least two (2) inches deep

to ensure proper grip and stability.

2. The SEAT PLATFORM must be inserted and

centered in the slot so that equal portions stick

out the front and back.

3. You must follow these guidelines for the seat

and foot rest panels regardless of which

slot/position is chosen for each one.

4. When the child is no longer using the tray with

crotch strap and the strap retainer, you may use

the seat platform with either the flat edge or

rounded edge in front BUT you must still comply

with guideline #2 above.

5. Of course, you will adjust the chair more often

in your child's early years. Thereafter be sure to

check the position of the platforms at least once

a year.

M P R

1x Allen Wrench 2xSmall Bolts 2xSmall Barrel Nuts

M5 x 40mm M5 x 9mm

TOOL

To ensure proper grip and stability:

K

O

V

W

O

V

W

M O V W

1x Allen Wrench 2xMedium Bolts 2xWasher 2xSpring Washer

M6 x 40mm

TOOL

To check the position of the seat and foot rest use these guidelines:

SEAT HEIGHT: Your child's elbows should be at the same height as where the tray

attaches.

FOOT REST POSITION: Your child's feet should rest comfortably flat on the foot rest

so his/her lower legs are straight.

The Connecting Rods are a little bit shorter than the distance between the left

and right sides to ensure the parts clamp together properly. PLEASE TIGHTEN

THE BOLTS EQUALLY ON BOTH SIDES.

4

Put the chair into its upright position on a flat,

level floor.

Level the chair, and then securely tighten ALL

of the bolts!

IMPORTANT: DO NOT DISCARD THE ALLEN.

WRENCH. You MUST regularly check the bolts

and retighten as needed using the ALLEN

WRENCH included with the chair! Check and

retighten 1-2 weeks after initial assembly.

Thereafter, check on at least a monthly basis.

As your child grows you can loosen the bolts

to remove the tray and change the position of

the seat and foot rest platforms.

Be sure to level the chair and then retighten the

bolts securely whenever adjustments are made.

Put Seat Cushion and Plastic Tray onto the chair.

I

L

Badger Basket EMBASSY 00934 Assembly Instructions Manual

Badger Basket EMBASSY 00934 Assembly Instructions Manual

Related papers

Other documents