2. Mircom
  3. LT-983 TX3-UGA and TX3-USGA

Mircom LT-983 TX3-UGA and TX3-USGA Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Mircom LT-983 TX3-UGA and TX3-USGA Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
LT-983 Rev 1 Page 1 of 2
Model TX3-UGA and TX3-USG
Universal Series Gooseneck Adaptors Installation
Instructions
Gooseneck Mounting
The TX3-UGA and TX3-USGA Universal Series Gooseneck Adaptors are used to connect the universal
series enclosures to a pedestal or other type of enclosure. The TX3 universal enclosure uses the supplied
screws and the four mounting holes at the back of the enclosure to connect to the gooseneck adaptor.
Figure 1: TX3-UGA Universal Series Gooseneck Adaptor
Feed the wires from the TX3 telephone access
through the centre large hole of the gooseneck
adaptor. Then mount the gooseneck adaptor to the
pedestal or other enclosure. Secure the gooseneck
with four screws whose holes surround the centre
large hole.
Place the TX3 backbox on top on the gooseneck
adaptor. Use the four 8-32” screws provided with the
TX3 panel to fasten the TX3 backbox to the goose-
neck adaptor through the mounting holes to the
standos on the gooseneck adaptor as shown by
dotted line.
0.625”
0.4” dia
0.4” dia
0.4” dia
0.4” dia
TX3 UNIVERSAL
ENCLOSURE
TX3-UGA
GOOSENECK ADAPTOR
Dimension of the Universal Enclosure without
the ush trim is:
16.25” H x 10.6” W x 2.75” D at bottom, 3” at top
LT-983 Rev 1 Page 2 of 2
Figure 2: TX3-USGA Slim Line Universal Gooseneck Adaptor
Installation instructions for UGA and USGA Gooseneck Adaptors:
1. Feed the wires from the TX3 telephone access through the centre large hole of the gooseneck
adaptor.
2. Then mount the gooseneck adaptor to the pedestal or other enclosure.
3. Secure the gooseneck with four screws whose holes surround the centre large hole.
4. Place the TX3 backbox on top on the gooseneck adaptor. Use the four 8-32” screws provided with the
TX3 panel to fasten the TX3 backbox to the gooseneck adaptor through the mounting holes to the
standoffs on the gooseneck adaptor as shown by dotted line.
TX3-USGA SLIM LINE
GOOSENECK ADAPTER
UNIVERSAL SLIM
LINE ENCLOSURE
Dimension of the Universal Slim Line Enclosure
without the gooseneck adapter is:
16.625” H x 5.85” W x 3.44” D at bottom, 4.5” D at top
/