ELPRO 805U-E Installation guide

Brand: ELPRO

Model: 805U-E

Category: Network antennas

Type: Installation guide

ELPRO Technologies Pty. Ltd. 2006Rev. 1.1

805U-E

Installation Guide

Statutory Requirements

Unlicensed operation limits the radio power. High gain aerials may only be used

to compensate for cable losses.

Systems should be designed for a duty factor of less than 10% to comply with

licence-free regulations.

Antenna Installation

805U-E Wiring

- +

10 – 30VDC

905U-E

HOSTHOST

RS232 Connections

PC’s

WARNING !

EXPLOSION HAZARD

DO NOT DISCONNECT WHILE

CIRCUIT IS LIVE UNLESS

AREA IS KNOWN TO BE NON

HAZARDOUS

RJ-45

Ethernet

Connection

Digital Input/ Output

Factory

Default

Switch

RS-485

Resistor

Terminator

Switch

Digital Output

Max 30VDC,

500mA

DC Relay Supply

DC Supply

RTS

CTS

DSR

DTR

DCD

RTS

CTS

DSR

DTR

DCD

RTS

CTS

DSR

DTR

DCD

RTS

CTS

DSR

DTR

DCD

805U-D

DB9

MALE

DTE HOST

DB9

FEMALE

805U-D

DB9

MALE

DCE HOST

DB9

MALE

PLC’s, Dataloggers

NOTE:

1. All connections to be SELV

2. DIO channels can be wired as either inputs or outputs.

3. Ethernet Port wiring is that of a hub or switch.

4. Connect “-” terminal to GROUND for surge protection

COM

DIO

COM

DIO

Digital Input

Voltage Free

Contact

Transistor

Device

RS485 Connection

30cm minimum

COLINEAR

ANTENNA

MAST

EARTH STAKE

IF GROUND CONDITIONS ARE

POOR, INSTALL MORE THAN

ONE STAKE

INSTALL ANTENNA ABOVE

LOCAL OBSTRUCTIONS FOR

MAXIMUM RADIO DISTANCE

TX/RX

805U-E

SURGE

ARRESTOR

(OPTIONAL)

COAXIAL CABLE

WEATHERPROOF

CONNECTORS WITH

“3M 23” TAPE

STRESS RELIEF LOOP

PROVIDE GOOD

GROUND

CONNECTION TO

MAST, MODULE

AND SURGE

ARRESTOR

GROUND Connection

on rear of Module

M4 x5mm

Connect “-“ terminal to

GROUND for surge

ELPRO 805U-E Installation guide

Brand: ELPRO

Model: 805U-E

Category: Network antennas

Type: Installation guide

Download PDF

report

ELPRO 805U-E Installation guide

ELPRO 805U-E Installation guide

Related papers

Other documents