Superior Life PQL-91835 LED T8 Plug & Go lamp is a high-quality lighting solution designed to replace traditional fluorescent lamps in existing fixtures. It features instant start capability and is compatible with electronic ballasts, emergency ballasts, and dimming ballasts. Installation is simple - just remove the old lamps, insert the PQL-91835 into the lampholders, rotate until it locks, and turn on the power.
Superior Life PQL-91835 LED T8 Plug & Go lamp is a high-quality lighting solution designed to replace traditional fluorescent lamps in existing fixtures. It features instant start capability and is compatible with electronic ballasts, emergency ballasts, and dimming ballasts. Installation is simple - just remove the old lamps, insert the PQL-91835 into the lampholders, rotate until it locks, and turn on the power.
LED LINEAR T8 PLUG & GO™ - 918XX
INSTALL INSTRUCTIONS
PREMIUM QUALITY LIGHTING® • www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 • 800-323-8107
Specifications subject to change without notice. Photos and line
drawings may not be to scale and are for general reference only.
DO NOT INSTALL THIS LAMP IN A PRE-HEAT LUMINAIRE.
THIS LAMP ONLY OPERATES ON ELECTRONIC BALLASTS. IF LAMP DOES NOT LIGHT WHEN THE LUMINAIRE IS ENERGIZED, REMOVE LAMP FROM
LUMINAIRE AND CONTACT LAMP MANUFACTURER OR QUALIFIED ELECTRICIAN.
CAUTION RISK OF FIRE - IF THE LAMP OR LUMINAIRE EXHIBITS UNDESIRABLE OPERATION (BUZZING, FLICKERING, ETC.), IMMEDIATELY TURN OFF POWER,
REMOVE LAMP FROM LUMINAIRE AND CONTACT MANUFACTURER.
SAFETY INFORMATION
• Check the lamp before installation, if there is any damage caused during transportation, do not install.
• Maintenance should be carried out by qualified personnel only.
• Do not stare at the light source with bare eyes for a long time, or beam into another persons eyes.
• Do not place any objects on the lamp.
• Keep the lamp away from flame or high temperature objects.
• Risk of electrical shock. Only replace with same type of LED tube.
• If the glass lamp tube is broken, the lamp must be disposed of immediately.
MAINTENANCE NOTES
• Disconnect lamp from power supply before any maintenance.
• Clean luminaire with dry cloth.
• Do not clean the lamp with corrosive chemicals.
• FOR EMERGENCY LIGHTING ONLY WITH BALLAST - Listed (FTBR/7), PHILIPS
EMERGENCY LIGHTING (E49328), Model B50 (Alternate RS), Rated 120/277V - 50/60Hz,
Damp Location Fluorescent Emergency Ballast.
• Ensure the temperature of the Tc point is under 131°F after the lamp has been
working properly for 2 hours, otherwise performance of lamp might not comply with
specifications.
SAFETY PRECAUTIONS
WARNING: Risk of Shock. Disconnect power before installation.
LED T8 lamp for use only with products described and installed in accordance with product specifications. LED T8 lamp to be operated with fluorescent
electronic ballast, emergency ballasts and dimming ballast.
WARNING: RISK OF FIRE, USE ONLY IN PLACE OF FLUORESCENT LAMPS SPECIFIED ON LABEL. RISK OF ELECTRIC SHOCK. SUITABLE FOR DAMP LOCATIONS.
Check ballast compatibility list before installation, only use lamp with qualified T8 fluorescent ballast.
!WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.
1. Make sure power is OFF.
2. Remove lens or diuser (if applicable).
3. Remove existing fluorescent lamps from the luminaire.
4. Bring LED lamp to luminaire and insert lamp pins into luminaire lampholders.
5. Rotate LED lamp until lamp locks in place. Ensure that the LED lamp front points
away from the back of the luminaire.
Note: Install one LED T8 replacement lamp for each fluorescent lamp removed.
6. Place lens or diuser back in place (if applicable).
7. Power On.
This product may cause interference to radio equipment
and should not be installed near maritime safety
communications equipment or other critical navigation or
communication equipment operating between 0.45-30 MHz.
LED LINEAR T8 PLUG & GO™ - 918XX
INSTALL INSTRUCTIONS
PREMIUM QUALITY LIGHTING® • www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 • 800-323-8107
Specifications subject to change without notice. Photos and line
drawings may not be to scale and are for general reference only.
INSTANT START BALLAST WIRING DIAGRAMS • CORRECT
• TWO LAMP BALLAST WIRING • CORRECT
• THREE LAMP BALLAST WIRING • CORRECT
• FOUR LAMP BALLAST WIRING • CORRECT
BALLAST
LAMP
WHITE
BLACK
LINE
BLUE
BLUE
RED
CAP
BALLAST
LAMP
WHITE
BLACK
LINE
BLUE
BLUE
RED
LAMP
BALLAST
LAMP
WHITE
BLACK
LINE
BLUE
BLUE
RED
CAP
BLUE
LAMP
BALLAST
LAMP
WHITE
BLACK
LINE
BLUE
BLUE
RED
BLUE
LAMP
LAMP
RED
BLUE
BLUE
RED
WHITE
BLACK
YELLOW
YELLOW
BALLAST
LAMP
LINE
CAP
LAMP
LAMP
RED
BLUE
BLUE
RED
WHITE
BLACK
YELLOW
YELLOW BALLAST
LAMP
LINE
LAMP
LAMP
LAMP
LED LINEAR T8 PLUG & GO™ - 918XX
INSTALL INSTRUCTIONS
PREMIUM QUALITY LIGHTING® • www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 • 800-323-8107
Specifications subject to change without notice. Photos and line
drawings may not be to scale and are for general reference only.
INSTANT START BALLAST WIRING DIAGRAMS • INCORRECT
• TWO LAMP BALLAST WIRING • INCORRECT
• THREE LAMP BALLAST WIRING • INCORRECT
• FOUR LAMP BALLAST WIRING • INCORRECT
BLUE
BLUE
RED
WHITE
BLACK BALLAST
LAMP
LINE
RED
BLUE
BLUE
WHITE
BLACK BALLAST
LINE
LAMP
BLUE
WHITE
BLACK BALLAST
LINE
LAMP
RED
BLUE
BLUE
BLUE
CAP
CAP
WHITE
BLACK BALLAST
LINE
LAMP
RED
BLUE
BLUE
BLUE
CAP
WHITE
BLACK BALLAST
LINE
LAMP
RED
BLUE
BLUE
BLUE
LAMP
WHITE
BLACK BALLAST
LINE
LAMP
RED
BLUE
BLUE
YELLOW
CAP
RED
YELLOW
WHITE
BLACK BALLAST
LINE
LAMP
RED
BLUE
BLUE
YELLOW
CAP
RED
YELLOW
CAP
CAP
CAP
WHITE
BLACK BALLAST
LINE
RED
BLUE
BLUE
YELLOW RED
YELLOW
LAMP
LAMP
WHITE
BLACK BALLAST
LINE
RED
BLUE
BLUE
YELLOW RED
YELLOW
LAMP
LAMP
WHITE
BLACK BALLAST
LINE
LAMP
RED
BLUE
BLUE
YELLOW
CAP
RED
YELLOW
CAP
CAP
WHITE
BLACK BALLAST
LINE
RED
BLUE
BLUE
YELLOW RED
YELLOW
LAMP
WHITE
BLACK BALLAST
LINE
RED
BLUE
BLUE
YELLOW RED
YELLOW
LAMP
LAMP
LAMP
-
1
-
2
-
3
Superior Life PQL-91835 LED T8 Plug & Go lamp is a high-quality lighting solution designed to replace traditional fluorescent lamps in existing fixtures. It features instant start capability and is compatible with electronic ballasts, emergency ballasts, and dimming ballasts. Installation is simple - just remove the old lamps, insert the PQL-91835 into the lampholders, rotate until it locks, and turn on the power.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
PQL 85001 User manual
-
Superior Life 82233 User manual
-
PQL 91492 User manual
-
Superior Life NovaLux 55536 User manual
-
Superior Life NovaLux 65W User manual
-
Superior Life L-2042 User manual
-
Superior Life NovaLux 55508 User manual
-
Superior Life PQL-83910 User manual
-
Superior Life PQL-556178WEM User manual
-
Superior Life PQL-83090W User manual
Other documents
-
PQL 90408 9040X LED Super Hybrid T8 User manual
-
RAB T8 Operating instructions
-
NOVALUX 90884 User manual
-
NOVALUX 55594 User manual
-
NOVALUX 55394 User manual
-
PQL 55241 User manual
-
NOVALUX 55525 User manual
-
NOVALUX 90302 User manual
-
PQL -80841 LED Track Lighting User manual
-
PQL -55537 120- 277V LED Linear High Bay User manual
