2. ITC
  3. OTLX-FF-LL

ITC OTLX-FF-LL User manual

  • Hello! I've reviewed the installation instructions for the ITC Table Leg OTLX-FF-LL. This document covers assembly steps, usage considerations, and safety information along with features such as easy slide-in locking tab. Feel free to ask me any questions about the installation or use of this table leg, I'm ready to help.
  • What is the intended use for the Ottawa Table Leg?
    What is the maximum load limit?
    What should I consider for installation?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
Find a solid, secure wall to mount your Ottawa leg system.
Place the wall base and mark the screw holes, pre-drill.
Screw in the base, using screws (not provided) appropriate
for mounting substrate.
1. Mount the table base onto table top (customer provided) using
designated screws based on material of the top. Make sure the
weight of the table top is evenly supported over the table leg.
Then align the table base to the leg and push down.
3.
INSTALLATION CONSIDERATIONS
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not sit on or lean on table, intended for use as a table only.
• The stiffness and rigidity of the wall mounting substrate has a direct effect on the sturdiness of the entire table system.
• 50lb load limit. Do not sit, stand, or lean on table.
Slide the leg into the wall base. To remove the leg, pull the
locking tab and slide the leg out.
2.
INSTALLATION INSTRUCTIONS
Ottawa™ Table Leg
Part#: OTLX-FF-LL
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00215 • Rev B • 12/16/22
Page 1 of 1
PARTS/TOOLS NEEDED:
Table Leg & Wall Base Table Base
(Purchased Separately)
Screws
(Not Provided)
Power Drill
(Not Provided)
Leg Mounting Clip
(Optional)
Optional Leg Clip:
Find a solid, secure wall and attach the clip using fasteners
appropriate for the mounting substrate. Snap the leg into the
clip for secure storage.
4.
/