8200-0206-08 Rev. A
Specifications
Pick-up Element 1/4” Sony Color CCD image sensor
Number of Pixels 512(H) x 492(V) <NTSC> / 512(H) x 582(V) <PAL>
Resolution 330 TV lines
Minimum Illumination 1 Lux / F2.0; 0 Lux (10 meter IR ON)
S/N Ratio >48dB (AGC MAX)
Electronic Shutter 1/60(1/50) to 1/100,000 sec.
Gamma Correction 0.45
White Balance Auto white balance
AGC Yes
Standard Board Lens F4.0mm / F2.0
Lens Angle (Diagonal) 61
o
Video Output 1.0 Vp-p composite, 75 ohm
Power Source 12VDC + 10%
Current Consumption 90 mA (IR OFF), 245 mA (IR ON)
Water Resistance IP 57
IR LED 12 units Infrared LED
Effective Range >10 Meters
Operating Temperature
0°C ~ 50°C (32°F ~ 122°F)
Dimensions (mm) 64.6 (Ø) x 105 (L)
Weight 550 g
Use only a regulated 12VDC power adaptor to operate this unit. If the input voltage is greater than
12VDC, it may reduce the IR LED lifetime. If the voltage is less than 12VDC, it may reduce the IR LED
effective distance.
General
This video camera employs a Sony Color CCD (charge coupled device) solid-state imaging device that
provides extremely long life and high reliability. The camera offers excellent reproducibility with low lag and
high burn resistance. It is not subject to distortion from magnetic fields and functions reliably across a wide
temperature range.
Features
• 1/4” Color CCD image sensor
• 330 TV lines.
• 1 Lux / F2.0, 0 Lux (10 meter IR ON).
• Water Resistance: IP 57
• IR LED: 12 units Infrared LED
• Effective Range: Over 10 Meters
• Automatic IR trigger-on under low illumination
• Automatic IR off under normal illumination
WARNING
At close range, Infrared light can seriously damage a person's vision. Install this Illuminator in such a manner
as to provide a minimum safety zone of 1.22m (4ft) between the Illuminator and the closest possible human
contact.
SERVICE WARNING
DO NOT LOOK DIRECTLY INTO AN OPERATIONAL IR ILLUMINATOR
Since IR light is invisible to the human eye, the only method of verifying a malfunctioning IR illuminator is to
observe the picture at the video output location.