Cirrus Design Section Front Matter
SR22T Foreword
P/N 13772-005 Front Matter-3P/N 13772-005 Front Matter-3
Revising the Handbook
Two types of revisions may be issued for this Handbook: Numbered
and Temporary.
Temporar y revis ions are pr int ed on yellow paper, nor mally cover only
one topic or procedure, and are issued to provide safety related
information or other time sensitive information where the rigor of
providing a numbered revision is not possible in the time allowed. All
the information needed to properly file a temporary revision is included
on the revision itself. Typically, a temporary revision is superseded and
replaced by the next numbered revision. A “Log of Temporary
Revisions” following the “List of Effective Pages” is provided to log
temporary revisions when they are issued. Typically, the “Log of
Temporar y Rev isions ” is replac ed at the nex t numbered revi sion.
Numbered revisions are printed on white paper, normally cover several
subjects, and are issued as general updates to the Handbook. Each
numbered revision includes an “Instruction Sheet,” a “List of Effective
Pages”, and a “Revision Highlights” page. The “Instruction Sheet” is
intended to assist the manual holder in removing superseded pages
and inserting new or superseding pages. The “List of Effective Pages”
shows the issue or revision status of all pages in the Handbook. The
“Revision Highlights” page gives a brief description of changes made
to each page in the current revision.
Identifying Revised Material
Each page in the Handbook has revision identification at the lower
inside corner opposite the page number. Original issue pages will be
identified by the words “Original Issue” at this location. In the event
that the majority of pages in the Handbook are revised, Cirrus may
determine that it is more effective to reissue the Handbook. Reissued
pages will be identified by the word “Reissue” followed by a letter
indicating the reissue level; for example, “Reissue A” Revised pages
will be identified by the word “Revision” followed by the revision
number at this location; for example, “Revision 2” (Original Issue,
Revision 2) or “Revision B1” (Reissue B, Revision 1).
Revised material on a page can be identified by a change bar located
at the outside page margin. See the outside margin of this page
adjacent to this paragraph for an example. Revision bars are not used
at reissues of the Handbook.
Original Issue