AZTEC ROPEVENTURE 4 ASSEMBLY INSTRUCTIONS
Rope Connecting Tubes (3 Pieces, 1 Long 2 Short) and Connecting Piece
Climbing Ropes
Aztec Plastic Walls
(4 Pieces)
Vertical Connecting
Poles (4 Pieces)
Ground Metals (4 Pieces)
1- Attach the 2 pieces aztec plastic walls to the ground metal. During the
assembly king figure must be on bottom left. (Picture 1)
(Picture 1)
King figure
Ground Metal
King
figure
Aztec Plastic
Wall
Ground
Metal
Bottom Bolt Cover
M10x60 Bolt
Top Bolt Cover
(Picture 2)
2- Bring to connecting piece to the middle of the long connecting tubes. Then squeeze the socket-head cap screw. Attach the
short tubes on right and left side on the connecting piece then squeeze the socket-head cap screw. (Picture 2)
Long Tube
Connecting
Piece
Short Tube
Short tube
(Picture 3)
3-
Place the poles to the concretes which you are going to install. Attach the rope connecting poles to the connecting pin on the
top of the poles. Use M10x60 Bolt, M10 Nut and bolt cover for attaching.(Picture 3)
Rope Connecting Tube
M10x60 Bolt
Bottom Bolt Cover
Muhafaza Kapağı
M10 Nut
Top BoltCover
Top Bolt Cover
Connecting
Pins
Bottom Bolt Cover
4- Remove the climbing ropes from their packages and attach to the poles and rope connecting tubes. Fix the bolts is on the
edge of the ropes with using M10 Nut and bolt cover. (Picture 4)
(Picture 4)
Displays
connection ropes
to the poles
Nut
Bottom Bolt Cover
Displays connection
the ropes to the tubes
Nut
Bottom Bolt Cover
(Picture 5)
5- Attach the aztec plastic walls to the auricles on the vertical connecting poles. Connect using bolts etc as before. (Picture 5)
Top Bolt Cover
M10x60 Bolt
Bottom Bolt Cover
6- Drill the all holes through the anchor hole on the ground metals. Use the anchors provided to secure the structure.(Picture 6)
(Picture 6)
Anchor
Concrete
Ground Metal
/
