Whirlpool AKR 641 GY Program Chart

Brand: Whirlpool

Model: AKR 641 GY

Category: Cooker hoods

Type: Program Chart

Whirlpool AKR 641 GY is a versatile kitchen appliance that combines powerful extraction with ambient lighting. Equipped with a 3-speed motor, it efficiently removes steam and fumes from your cooking area. Its pull-out steam deflector enhances extraction efficiency, while the grease filter effectively traps grease particles. The halogen lighting ensures clear visibility during cooking. Installation is simple with the included support brackets and collar for flexible duct connection.



5019 318 33068

AKR 641 - AKR 643

KARTA INSTALACYJNA

Minimalna odleg³oæ od palników: 65 cm (palniki elektryczne), 75 cm (palniki

gazowe, olejowe lub wêglowe). Podczas monta¿u nale¿y przestrzegaæ kolejnoci

numeracji (1

.....) oraz odpowiednich instrukcji. Nie pod³¹czaæ urz¹dzenia

do zasilania, zanim nie zostanie zakoñczony ca³kowicie jego monta¿. Uwaga!

Rura odprowadzaj¹ca dym i parê oraz kolanka nie s¹ dostarczane i nale¿y je

zakupiæ oddzielnie.

POPIS INSTALACE

Minimální vzdálenost od sporákù: 65 cm (elektrické sporáky), 75 cm (sporáky na

plyn, naftu nebo uhlí). Pøi montái sledujte èíslování (1

.....) a pøísluné

pokyny. Spotøebiè pøipojte k elektrické síti a po úplném dokonèení instalace.

Upozornìní! Nasávací trubka a pásky k upevnìní nejsou souèástí vybavení,

musíte je zakoupit.

INTALAÈNÁ SCHÉMA

Minimálna vzdialenost' od sporáka: 65 cm (elektrické sporáky), 75 cm (plynové

sporáky, sporáky na naftu alebo uhlie). Pri montái postupujte pod¾a èíslic

.....) a dodrujte prísluné pokyny. Spotrebiè nezapájajte do siete, kým

nie je intalácia úplne ukonèená. Upozornenie! Rúra na odvádzanie dymov a

upevòovacie svorky sa nedodávajú, musíte ich kúpit' samostatne.

ÜZEMBE HELYEZÉSI ÚTMUTATÓ

A tûzhelytõl való minimális távolság: 65 cm (elektromos tûzhely), 75 cm (gáz-,

olaj- vagy széntüzelésû tûzhely). A felszereléshez kövesse a számozást

.....) és a vonatkozó utasításokat. A készüléket csak akkor szabad áram

alá helyezni, ha a beüzemelés már megtörtént. Figyelem! Az elvezetõ csõ és a

rögzítõpántok nem tartozékok, így azokat külön meg kell vásárolni.

31833068.fm Page 1 Monday, December 23, 2002 10:00 AM



5019 318 33068

AKR 641 - AKR 643

ÈÍÑÒÐÓÊÖÈÈ ÏÎ ÓÑÒÀÍÎÂÊÅ

Ìèíèìàëüíîå ðàññòîÿíèå äî êîíôîðîê: 65 ñì (ýëåêòðè÷åñêèå

êîíôîðêè), 75 ñì (ãàçîâûå, êåðîñèíîâûå èëè óãîëüíûå). Ïðè ìîíòàæå

âûïîëíÿéòå äåéñòâèÿ â ñîîòâåòñòâèè ñ íóìåðàöèåé (1

.....) è

èíñòðóêöèÿìè. Íå ïîäêëþ÷àéòå ïðèáîð ê ýëåêòðè÷åñêîé ñåòè äî

îêîí÷àíèÿ óñòàíîâêè. Ïðåäóïðåæäåíèå! Âûòÿæíàÿ òðóáà è êðåïëåíèÿ íå

âõîäÿò â êîìïëåêò ïîñòàâêè è ïðèîáðåòàþòñÿ îòäåëüíî.

ÊÀÐÒÀ ÇÀ ÈÍÑÒÀËÈÐÀÍÅ

Ìèíèìàëíî ðàçñòîÿíèå îò ïå÷êè: 65 ñì (åëåêòðè÷åñêè ïå÷êè), 75 ñì

(ïå÷êè ñ ãàç, íàôòà èëè âúãëèùà). Çà ìîíòàæ ñëåäâàéòå íîìåðàöèÿòà

.....) è ñúîòâåòíèòå èíñòðóêöèè. Íå âêëþ÷âàéòå çàõðàíâàíåòî

íà óðåäà, äîêàòî èíñòàëèðàíåòî íå å çàâúðøåíî äîêðàé. Âíèìàíèå!

Òðúáàòà çà îòâåæäàíå íå å ïðåäîñòàâåíà è òðÿáâà äà ñå çàêóïè

îòäåëíî.

FIªA DE INSTALARE

Distanþa minimã de la arzãtoare: 65 cm (arzãtoare electrice), 75 cm (arzãtoare pe

bazã de gaze, motorinã sau cãrbune). Pentru montare urmaþi numerotarea

.....) ºi instrucþiunile corespunzãtoare. Nu branºaþi aparatul la curent

pânã când nu terminaþi definitiv operaþia de instalare. Atenþie! Tubul de evacuare

ºi manºoanele de fixare nu fac parte din dotare ºi trebuie sã fie cumpãrate

separat.

INSTALLATION SHEET

Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil or

coal cookers). To assemble follow the numbers (1

.....) and relative

instructions. Do not connect the appliance to the electrical power supply until

installation is completed. Warning! The exhaust pipe and clamps are not

supplied and must be bought separately.

RUS

31833068.fm Page 2 Monday, December 23, 2002 10:00 AM



5019 318 33068

AKR 641 - AKR 643

31833068.fm Page 3 Monday, December 23, 2002 10:00 AM



5019 318 33068

AKR 641 - AKR 643

31833068.fm Page 4 Monday, December 23, 2002 10:00 AM



5019 318 33068

AKR 641 - AKR 643

Preliminary information for installing the hood:

Disconnect the power supply at the domestic main switch before carrying out electrical connections.

1. Fix 2 support brackets D (Fig. 1) to the sides of the wall unit (one each side) using 2 screws per bracket

(the brackets must be parallel with the lower edge of the unit).

Position the support bracket so that it is against the back of the wall unit, making sure that the rear edge

of the bracket matches the back of the hood.

Drill an opening at the top of the wall unit for the exhaust pipe and the power supply cable.

2. Fix 2 support brackets E (Fig. 2) to the sides of the hood (one each side).

a. Pull out the deflector;

b. remove the grease filter/s;

c. from the inside of the hood, secure the support brackets using two screws P per bracket, making

sure to place the brackets as high as possible (near the outlet duct), then tighten the screws.

3. Fit the hood inside the wall unit, being careful to position the hood bracket E above the wall unit bracket

D (Fig. 1-2).

Insert the power supply cable through the opening made for the purpose.

4. Secure the hood with two screws in front (Fig. 3 - one each side).

5. Carry out the electrical connection to the mains power supply, only turn on the power supply with

assembly completed.

6. If necessary, adjust the alignment by loosening the screws P of the brackets E mounted on the hood

(Fig. 2) until the hood and the lower edge of the wall unit line up perfectly, then tighten the screws again.

7. Adjust the deflector slideout stroke according to the depth of the wall unit by adjusting the two retainers

F (Fig. 5). In this way the front will be perfectly aligned with the wall unit.

a. Loosen the screws of the retainers F;

b. Adjust by moving the retainers backwards or forwards;

c. tighten the screws of the retainers.

8. Fix an outlet duct to the collar C supplied. The outlet duct diameter should be the same as that of the

collar (Fig. 4). The exhaust pipe must be long enough to vent externally (extractor version) or must reach

the top of the wall unit (filter version).

9. Fix the collar C (snap-close) to the top section of the hood discharge.

To facilitate installation, the collar has a mark G that must match the specific guide H on the exhaust

duct.

10. Complete the installation of the exhaust duct.

Refit the grease filter/s, connect the hood to the power supply and check for correct hood operation.

INSTALLATION - ASSEMBLY INSTRUCTIONS

PL SK H RUS

BG RO GB

31833068.fm Page 19 Monday, December 23, 2002 10:00 AM



5019 318 33068

AKR 641 - AKR 643

1. Control panel.

2. Grease filter

(1 or 2 pieces depending on model).

3. Grease filter spring release handles.

4. Lighting unit.

5. Pull-out steam deflector.

6. Extractor unit body.

Removing and/or washing the grease

filter/s

1. Disconnect the electrical power supply.

2. Remove the dirty grease filter/s by pulling the

handle first backwards and then downwards

(Fig. 1).

3. After cleaning the grease filter refit in reverse

order, making sure the entire extraction surface

is covered.

Replacing bulbs

1. Disconnect the electrical power supply.

2. Use a small screwdriver or any other suitable tool

to prise off the lamp cover (Fig. 2).

3. Remove the burnt-out bulb.

4. Replace using 40 W max E14 bulbs only.

5. Replace the lamp cover so that it clicks into

position.

Fitting or renewing the carbon filter:

1. Disconnect the electrical power supply.

2. Remove the grease filter/s (Fig. 1).

3. If the carbon filters are already mounted (one or

two filters, depending on the model, covering the

motor protection grille) and need renewing, turn

the central handle (Fig. 3 - c) anticlockwise until

the filters release.

4. If the carbon filters are not already mounted,

locate the filters to cover the motor protection

grilles (two protection grilles - two carbon filters,

one protection grille - one carbon filter), then

turn the central handle (Fig. 3 - c) of the filters

clockwise.

5. Refit the grease filter/s (Fig. 1).

CONTROL PANEL

Light switch.

The switch has two positions

(lights OFF - lights ON).

To switch on the lights: move the switch to the

right.

Motor switch.

The extraction speed switch has 3 settings,

depending on the amount of steam and fumes.

To increase the extraction speed: move the

switch to the right.

Fig. 1

Fig. 2

Fig. 3

PRODUCT SHEET

PL SK H RUS

BG RO GB

31833068.fm Page 20 Monday, December 23, 2002 10:00 AM

Whirlpool AKR 641 GY Program Chart

Brand: Whirlpool

Model: AKR 641 GY

Category: Cooker hoods

Type: Program Chart

Download PDF

report

in other languages

italiano: Whirlpool AKR 641 GY
slovenčina: Whirlpool AKR 641 GY

Whirlpool AKR 641 GY Program Chart

Whirlpool AKR 641 GY Program Chart

in other languages

Related papers

Other documents