User manual
Please read these instructions carefully before beginning installation and
assembly and save them for future use. This will ensure the safety of your
children.
Congratulations on purchasing this playground equipment! We are confident that this
playground is safe and durable and that it will bring joy to your children for several
years.
Play equipment produced by Jurmalas Mežaparki Ltd. is manufactured with high
responsibility for the quality of materials and technical solutions in order to create a
safe environment for your children. The equipment has been designed and
manufactured in accordance with the EN 71 1.2 and 1.8 European safety standards
for domestic use, given that it is installed, assembled and used according to these
instructions. Do not make any changes or improvements when assembling
equipment. This equipment is intended for domestic use only. Installation and use in
public spaces (parks, guest houses, etc.), schools or kindergartens is not permitted.
Misuse, improper loading or overloading can lead to user injury.
Safety
This playground equipment requires a safety zone as illustrated in the manual, which
should be free from any kind of objects (trees, fences, buildings, lines for drying
clothes, rocks, curbs, pools, etc.), as well as garden elves or other objects that may
be an unnoticed barrier during play. The playground cannot be installed on a slope,
since it may create an additional load on the playground and pose a hazard to the
children. The angle of inclination should be no more than 5°. Do not install the
equipment on a hard surface such as concrete, pavement or asphalt. Falling on such
surface can be traumatic.
Installation
Children must not participate in the assembly and installation process, as loose parts
falling and/or tool usage could cause injury. Please note the operational safety
equipment – safety glasses, gloves, etc. The installation requires two adults capable
of lifting and connecting large details. The required tools are the following: tape
measure, socket driver, electric screw driver, leveller, Allen key and a hammer (see
specific details in the manual).
After unpacking the parts, make sure that all parts are delivered in accordance with
the installation manual. If any parts are missing, the assembly may only be
continued after receiving all details. Do not step on the structure before it is fully
assembled and levelled. All screws must be tightened not to leave any sharp edges,
but avoid over-tightening them. Use only the strengthening indicated in the
instructions listed directly under the screw diameter and length.
Do not connect any other elements to the equipment (ropes, rungs, chains, swings)
– this may significantly reduce the safety of the playground. The required swing seat
height from the ground is 35 cm. Any rope which is designed for installation must be
fixed and strengthened at both ends. Unsuspended, free hanging rope can cause
accidents while playing. Allow children to use the equipment only when it is fully