2. Schacht
  3. Treadle Tracker

Schacht Treadle Tracker User manual

  • Hello! I'm your chat assistant and I've reviewed the user manual for the Schacht Treadle Tracker. This document provides clear instructions on how to install the tracker on your loom, including mounting the bracket and securing it with screws. It also lists the included parts and required tools. I'm ready to answer any questions you have about the Treadle Tracker and its installation process.
  • What is the purpose of the Treadle Tracker?
    What parts are included with the Treadle Tracker?
    What tools do I need for installation?
    Where on the loom should the mounting bracket be attached?
PARTS
mounting bracket
#8 Phillips screws (2)
clip stick
Schacht Spindle Co., Inc.
6101 Ben Place
Boulder, CO 80301
schachtspindle.com
The Schacht
Treadle Tracker
TOOLS YOU WILL NEED
Phillips screw driver
Drill and 1/8" drill bit
INSTALLATION
1. Attach the treadle tracker mounting bracket to the rear
castle cross piece of your loom. On a low castle loom this
is the cross piece behind the shafts that connects the cas-
tle sides. On a high castle loom this is the rear cross piece
that forms the back side of of the high castle tray. You can
center the mounting bracket or place it to one side.
2. Use the mounting bracket as a template to drill two
1/2”deep x 1/8” diameter holes in the rear castle cross.
Hold the bracket in position against the rear castle cross
with the lip of the mounting bracket toward the front of
the loom.
3. Attach the bracket with the two screws.
15 100 100 10 67 49 36 0 42 5 92 4
38 37 94 24 0 76 81 31 90 7 0 36
3 66 100 9 49 24 0 70 0 42 59 49
No more taping
your draft to the
front of your loom.
With the Schacht
Treadle Tracker, you
can display your
draft or treadling
sequence in easy
view.
/