REMOVE DRAWERS IN
ORDER TO MOUNT BOX
•Pull the drawer fully
open so Levers are
visible.
•Push "DOWN" on the
right lever, and "UP"
on the left lever.
•Holding levers in
place, pull drawer
toward you.
PRODUCT DESCRIPTION PRODUCT DIMENSIONS SPECIFICATIONS WARRANTY
30" FRAME WIDTH
Product Dimensions Product Features
ROD HANDLE
SOFT-CLOSING
DRAWER TRACK
REMOVABLE DRAWER
HORIZONTAL DIVIDER
COMBINE MULTIPLE COMPONENTS TOGETHER
INTO UNLIMITED COMBINATIONS
DE-MD30
ON BOTTOM
COMPONET FEATURES
A 1/16" RAISED FRAME
VISIBLE EDGE ENABLING
YOU TO PLACE TWO OR
MORE COMPONETS SIDE
BY SIDE OR ONTOP OF
ONE ANOTHER CREATING
ONE SINGLE LARGER
FUNCTIONING COMPONET
OF YOUR OWN CHOOSING
DE-SD30
ON TOP
23" DEPTH
10" FRAME HEIGHT
Designer Series, Raised Style - 30"
Wide x 10" Height Single Drawer
w/Divider & Peg-Legs
30" Wide x 10" Height
Single Drawer
Item No. DE-MD30
30" WIDTH x10" HEIGHT x23"
DEPTH (PRODUCT SIZE) 28-1/2"
WIDTH x8" HEIGHT x22" DEPTH
(CUT-OUT)
PEG-LEG
28-1/2" WIDTH
INSERT DRAWER
USE DRILL TO SECURE SCREWS
IN PLACE THROUGH HOLES
SCREW NOT
INCLUDED
USE WRENCH TO SCREW
PEG-LEG DOWN TO FLOOR
BASE OR STACKED BLOCKS
- USE LEVELER TO CONFIRM
ELEVATION
ISLAND WALL CUT-OUT SIZE IS
28-1/2" WIDTH BY 8" HEIGHT BY 22" DEPTH
4-1/2"
HEIGHT
DE-MD30
IN MIDDLE
STACK MULTIPLE
COMPONENTS ONTOP
OF ONE ANOTHER
2. REMOVE DRAWERS
3. MOUNT DRAWER & LOWER LEGS
1 . INSERT COMPONET
Product Installation
See SUNSTONE manufacture website for additional
product support and product tutorials:
www.sunstonemetalproducts.com
IMPORTANT!! - ROD HANDLES ARE MOUNTED TO INSIDE OF EACH
PANEL, YOU MUST UNSCREW EACH ONE AND MOUNT ON OUTSIDE OF
DRAWER OR DOOR PANEL.
HAVE 22"
CLEARANCE
INSIDE DEPTH
Frame is made from 16 gauge 304 SS,
and panel's are made from 18 gauge
304 SS. Inside Drawer Box is made with
20 gauge 201 SS. Handle is Solid 304
SS.
•EXTERIOR FINISH -----------------3 YEARS
•ROD HANDLES---------------------3 YEARS
•DRAWER TRACK------------------ 1 YEAR
•PEG-LEGS--------------------------- 1 YEAR
/