Huviron SK-HT21AI User manual

  • Hello! I am an AI chatbot trained to assist you with the Huviron SK-HT21AI User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
FULL HD-TVI(1080P)
VANDALPROOF & WATERPROOF
IR D&N DOME CAMERA
SK-V251IR(D)/HT21AI
MANUAL
1. Camera installation
(1)Fix the camera set with the supplied screws on ceiling or wall
mount.Ifyoudon'tusesuppliedscrews,thecameramayfalloff.
(2)Please refer to '3. Camera angle adjustment' regarding adjust
cameraangle.
 (3)Lensadjustment(Vari-focalLensonly)
AfteropeningtheLEDcover,
①By turning the "Tele-Wide" knob,
you can access a range of focal
lengthswithinspecifiedlimits.
②Since then, by turning the "Near-
Far" knob, you can set the focus
towardthewantedobject.
 (4)Re-assemblethecamera.
◐ HOW TO INSTALL
◐ DIMENSION
1.Youcaninstallthecameraindoorsoroutdoors.
2.Chooseanideallocationforthecamera,sinceacameraunitmust
beprotectedagainstvibration.
3.Becarefulnottoscratchthecameraunit,especiallylensordome
cover.
4.Use the camera within the temperature(-45℃~50℃). [W/
HEATER(option)]
5.Avoidanydirectsunlighttowardthelens.
6.UsetheACadaptor12VDC,1Aregulated.Dualvoltageproduct
canuse24VAC,1Aadaptor.(option)
◐ PRECAUTION
Iftheproductistobeputoutofoperationdefinitively,
takeittoalocalrecyclingplantforadisposalwhich
isnotharmfultotheenvironment.
<Ceiling mount>
<Wall mount>
1
2w
NFT
2. Pipe application
 (1)Removethescrewforfixingacableonthebottomofthebase.
 (2)OpentheDOMECOVER.
 (3)RemovetheTAPCOVERandplacethecablesthere.
 (4)Afterdistributingcables,usetheTEPLONtapetowipethepipe.
 (5)Combinethepipetothebase.
 <Caution>Ifyoudon'twipeTEFLONtapeonpipe,itmightcause
troublesonwater-resistant.
3. Camera angle adjustment :
(1)Pan adjustment : Grasp the disk of camera and then adjust
directiontotherightorleft(-160°~190°)
 (2)Tiltadjustment:GrasptheLEDcoverofcameraandthenadjust
directiontotheupordown(6°~90°)
(3)Roll adjustment : Grasp the camera holder and then rotate
(-178°~178°)
 <Caution>Ifyoutrytoadjustthecameraoutoflimitedangle,itmight
causetroublesanddamagetocamera.
1.1/2.9"SONYCMOSsensor
2.FullHD(1920x1080)Resolution
3.DAY&NIGHTFunction
4.WDR(WideDynamicRange)Function
5.3DDNRFunction
6.Privacymaskfunction16area
7.OnScreenDisplaymenu
8.Intelligentmotiondetection
9.Output:HD-TVI/CVBS
10.Protocol:PELCO-C
11.IP68(Waterproof)
12.DurableMATERIAL:Body-Aluminum,Dome-Polycarbonate
13.Thiscameraisincrediblyflexibletoinstallwithits3-axiscamera
construction, which makes the camera ceiling, wall or slope
mountable
14.20Mrangevisibleintotaldarknesswith24pcsofIRLEDs.(Indoor)
15.Upto500MFullHD-TVITranmissionviaCoaxialcable.(Maximum
tranmissiondistancemayvarywithtypeofcoaxialcable)
◐ FEATURES
SCREW Tp1 4X25 3EA
MOUNT HOLE PLATE(STICKER) Ø3.5
Ø30
SCREW Tp1 4X25 3EA
MOUNT HOLE PLATE(STICKER)
Ø3.5 Ø30
Put a sticker on the ceiling and make holes
according to the spots marked on a sticker
Put a sticker on the wall and make holes
according to the spots marked on a sticker
CABLE
PIPE
TEFLON TAPE
TAP COVER
CABLE FIXING SCREW
DOME COVER
LED COVER
DISK
ROTATION
U
D
R
L
CAMERA HOLDER
Ø100
Ø150.5
45
95.6
Ø129
1. How to use the jog lever
◐ FUNCTION SETTING
①SET : Usedtoaccessthemenuandconfirmselection.
②UP, ③DOWN : Usedtomovethecursortoupordown.
LEFT, ⑤RIGHT : Used to move the cursor to left or right and
changethevalue.
⑥EXT-VIDEO : Extravideooutputterminalforinstallation.
 Plugyourtestmonitorinhear.Thecableisoption.
※All specification is subject to change without notice to improve the quality. 3B26624A
2. OSD menu structure
◐ CAMERA / STRUCTURE SPECIFICATION
SK-V251IR(D)/HT21AI
VIDEO
Image Sensor 1/2.9"SONYCMOS
Total Pixels 2010(H)1108(V)=2,227,080(pixel)
Active Pixels 1944(H)1092(V)=2,122,848(pixel)
Scanning System ProgressiveScan
Resolution
Digital:1920X1080p(1080p,30/25fps)
1280X720p(720p,60/50fps)
Analog:700TVL
S/N Morethan50dB(AGCOFF)
Video Output HD-TVI
Analog:NTSC,PAL(withoutWDR)
Min.Illumination Color:1.0Lux,BW:0.5Lux
ColorDSS:0.002Lux,BWDSS:0.001Lux
LENS TYPE
Lens Type DCAutoIris
Focal Length f=2.8(W)~12.0(T)mm
OPERATIONAL
On screen display Yes
Day & Night TDN(Auto/Day/Night)
Brightness 0~20steps
Shutter Speed Auto/Manual(1/30(1/25)~1/60000)
Sens-up OFF/×2~×8
AGC 0~20steps
Backlight WDR/BLC/OFF
HLC ON/OFF
D-WDR ON/OFF
White Balance Auto/Autoext/Manual
Sharpness 0~10steps
Digital Noise Reduction (3D) High/Middle/Low/Off
Digital Zoom ON/OFF(X1~X64)
Motion Detection ON/OFF
Privacy Masking ON/OFF(16ZoneSelectable)
Mirror H/V/H&V/OFF
Defog ON/OFF
STRUCTURESPECIFICATION
MECHANICAL
Dimension Ø150.5Ⅹ95.6(H)mm
Weight Approx.800g
ENVIRONMENTAL
Ingress Protection IP68
Operating Temp -45°C~50°C
Humidity 0%to90%
FUNCTION
Protocol PELCO-C
ELECTRONICAL (POWER CONSUMPTION)
Supplied Voltage DC12V±10%orAC24V±10%DualVoltage
Current Consumption Max.450mA(at12VDC,24VAC):LEDON
LED IRLED24PCS
Heater Option
Fan Option
CERTIFICATION
CE, FCC, ROHS Yes
6
1
2
4
3
5
3. How to control through Pelco-C communication
 1)Matchthecamerawithcontroller'sID,baudrateandprotocol
 2)Up,Down,LeftandrightissameasUp,Down,Leftandrightof
Pelco-Ccontrol
 3)EntersameasmenukeyorIRISopenkeycontrol
Function
setting menu Sub menu Summary
1.
EXPOSURE
BRIGHTNESS Adjustbrightnesslevel0(dark)~20(bright)
LENS-DC SelectwhenuseofDCAuto-Irislense/except
thespecialcases,DCisstandardModel
AEMODE SelectAEMODE
SHUTTER CanbesetinAUTOorMANUAL
SENS-UP SelectmaximumDSS(DigitalSlowShutter)OFF,x2~X8
AGC SelectAutoGainControl
2.
WHITE BAL
AWB SelectWHITEBALANCEmode
▷AUTO Automaticallyadjustscoloraccordingtothelighting
▷AUTOext FasterextensionversionofAuto
MANUAL Adjustthewhitebalancemanually
3.
BACK
LIGHT
BACKLIGH SelectBacklightcompenstaionmode
WDR AdjustWDRlevel-Low/Middle/High
HLC SelectHighLightCompensation.
BLC
▷AREA ControlBLCareaaccordingtolightcondition.
▷POS-X AdjustthewindowX-Axisposition
▷POS-Y AdjustthewindowY-Axisposition
▷SIZ-X AdjustthewindowX-Axissize
▷SIZ-Y AdjustthewindowY-Axissize
4.
DAY&
NIGHT
DAY&NIGHT SelectDay&Nightmode
AUTO-CDS
Automaticswitchingbetweendayoperation
(colormode)andnightoperation
(blackandwhitemode)
▷IR-LED LEDOn/OffControl
▷ANTI-SAT CompensatewhenIRhuntinghappens.
Whenyouusethisfunction.
▷AGCTHRS Day&Nightchangelevel.Higherlevelmakethenight
modechangedinlowerillumination.
▷AGC
MARGIN Daytonightandnighttodayswitchmargin
▷DELAY 2~60second
5.
IMAGE
DNR SelectDigitalNoiseReduction
SHARPNESS Adjustsharpnesslevel
COLORGAIN AdjustColorgainvalue0~20Steps.
GAMMA Selectegammamode.0.45~0.65
D-WDR SelectDigitalWDR(WideDynamicRange)
DEFOG Carryoutdefogfunction.
SHADING SelectLensshadingcompensation.(OFF/ON)
MIRROR
H-Flip:Flipthepicturehorizontallyonthescreen
V-Flip:Flipthepictureverticallyonthescreen
Rotate:Flipthepicturehorizontally
&verticallyonthescreen
6.
SPECIAL
TITLE Cameratitleeditanddisplayon/offselect
PRIVACY Hideanareayouwanttohideonthescreen
MOTION Whenthereismovementofthesubjectonthe
screen,therewillbemotiondetection
D-ZOOM Selectdigitalzoommagnification.Max8x
Function
setting menu Sub menu Summary
6.
SPECIAL
LANGUAGE SelectLanguage
COMM. SetupCameraIDandbaud-rate.
(Pelco-D/PAutodetect)
7.
SYSTEM
IMAGE
RANGE Selectpedestallevelscale
HDFormat SelectHDoutputformat.1080p
HDFPS SelectHDoutputframerate.
1080p30,25
CVBS SelectCVBSoutputmode.NTSCorPAL
8. RESET Allthesettingswillberestoredtothefactorydefault
9. EXIT Escapethemenu
/