Page is loading ...
148(L)mm
210(H)mm
148(L)mm
Fortress_MD3817 (Eng)_Cover_Date: 17.4.13
2000W HAIR DRYER
User Manual
Model No.: KMD3817
*Before operating the unit, please read this manual
thoroughly and retain it for future reference.
2
Fortress_MD3817 (Eng)_Blank Fortress_MD3817 (Eng)_Index_Date: 17.4.13
148.5(L)mm
210(H)mm
148.5(L)mm
CONTENT PAGE
SAFETY INSTRUCTION 3-4
OPERATION INSTRUCTION 5-6
MAINTENANCE INSTRUCTION 6
SPECIFICATION 7
WARRANTY 8-9
3 4
Fortress_MD3817 (Eng)_P3_Date: 18.4.13 Fortress_MD3817 (Eng)_P4_Date: 18.4.13
148.5(L)mm
210(H)mm
148.5(L)mm
SAFETY INSTRUCTION
1. To avoid electric shock, risk of fire or injury, please read the user manual carefully before
using the appliance and keep it for future reference.
2. Please use suitable power source (220-240V~/50Hz).
3. Do not use the appliance under direct sunshine.
4. Please turn off and unplug the appliance before cleaning or maintenance.
5. When the appliance is not in use for a prolonged period, please turn it off, unplug it and
pack it well. Then store it in dry cool place.
6. Forbid to put flammable and explosive objects around the appliance, and do not use the
appliance in an environment full of flammable gas and powder.
7. Do not put any objects on the appliance and do not put the appliance immediately
below a socket-outlet.
8. Do not touch the air outlet when operating.
9. Please keep the air inlet and outlet unblocked to minimize the risk of fire and
malfunction.
10. Do not let power cord touch and near air outlet. It will damage the insulation layer of
wires.
11. Ensure no water or raindrop into the appliance in order to avoid electric shock. Do not
put flammable objects or wet cloths on the air outlet in order to avoid short circuit or
fire.
12. Please do not place air inlet or outlet near to curtain or wall when operating because it
will block air current and cause a risk of fire. The appliance should be installed at
minimum distant of 10 cm from the wall or other obstacle.
13. Please do not insert any objects into air inlet or outlet in order to avoid electric shock.
14. After a period of operation, there may be abnormal noise and uneven air volume
because of dust blocking airflow. It will disappear after cleaning the dustproof filter.
15. WARNING: In order to avoid overheating, do not cover the appliance with flammable
materials, such as cloths or paper.
16. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
17. Always unplug appliance immediately after use.
18. Never use in a damp room, or near a sink or other vessel filled with water.
19. When the hairdryer is used in a bathroom, unplug it after use since the proximity of
water presents a hazard even when the hairdryer is switched off.
20. Always dry your hands before use.
21. For additional protection, the installation of a residual current device (RCD) having a
rated residual operating current not exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
2000W HAIR DRYER 2000W HAIR DRYER
22. Do not place in or drop into water or other liquids. If an appliance falls into water
unplug appliance at mains socket immediately. Do not reach into the water.
23. An appliance should never be left unattended when plugged in.
24. Close supervision is necessary when using this appliance on children or infirm persons.
Children should always be supervised to ensure they do not play with the appliance.
25. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
26. Use this appliance only for its intended use as described in this manual. Only use the
attachments supplied by the manufacturer.
27. Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged, or immersed in water.
28. For safety reasons, broken or damaged mains cord may only be replaced or repaired by
an equivalent cord from the manufacturer or qualified technician. Please do not repair
or replaced by yourself.
29. Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
30. Do not use outdoors or operate where aerosol (spray) products are being used or where
oxygen is being administered.
31. Do not use an extension cord with this appliance.
32. This product’s attachments will become hot during use. Do not let the heated surfaces
come into contact with bare skin and eyes. Always hold the appliance by the handle and
not by the cable.
33. Do not place the appliance directly on any surface while it is hot or plugged in.
34. Attachments may become hot during use. Allow them to cool before handling and
storing.
35. Do not operate this appliance with a voltage converter.
36. Do not operate the machine without supervision. If you should leave the work place,
always switch the machine off or remove the plug from the socket (pull the plug itself,
not the lead).
37. This appliance is designed for household use only.
38. Never block the air suction openings or place in on soft surface (bed, couch or towel,
etc.).
WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels
containing water.
“Caution!! Do not use this appliance
near bathtubs, showers, basins or
other vessels containing waters.”
5 6
Fortress_MD3817 (Eng)_P5_Date: 16.7.13 Fortress_MD3817 (Eng)_P6_Date: 17.4.13
148.5(L)mm
210(H)mm
148.5(L)mm
2000W HAIR DRYER 2000W HAIR DRYER
OPERATION INSTRUCTION
When using electrical appliances, especially when children are present, basic safety
precautions should always be followed, including the following:
Initial and General Use
Fully unwind the mains cable.
Fit on a nozzle. You can dry single hair locks by concentrating the flow of hot air with
the hairdressing nozzle. The diffuser is the ideal solution to dry curly hair without losing
volume.
Only connect the machine to a properly installed safety socket. Ensure that the voltage
indicated on the identification plate corresponds with the mains voltage.
Setting the Temperature Level (left switch ):
Position 1: low temperature
Position 2: medium temperature for gentle drying and shaping
Position 3: high temperature for rapid drying
Setting the desired air stream strength (right switch ):
Position 0: OFF
Position 1: gentle steam of air
Position 2: strong stream of air
Cool shot function ( COOL ):
With this switch it is possible to interrupt the heating process so
it is ideal for styling and shaping your hair. You can still adjust
the air stream strength.
Protect function ( ):
With a “Protect” switch to keep the constant temperature to dry your hair.
Normal function ( ):
With this switch stop the constant temperature function and return to a normal level.
MAINTENANCE INSTRUCTION
Cleaning and caring
Recommend to clean the air suction opening from time to time with a fine brush. Clean the
housing with a soft, dry cloth without additives.
Ensure that the unit is switched off and unplugged before cleaning and storage. Leave the
appliance until it turns to cool before putting it away.
Removing the air suction cover
Remove the cover after turning the cap through approximately 30 degrees against anti-
clockwise direction. Remove the intake filter and clean under running water. Dry the filter
well before mounting again.
Fix the air suction cover
Move the arrow “ ” on the suction cover to match the arrow “ ” on the hair dryer.
Note : Turn off and unplug the appliance before cleaning or maintenance.
This device has been tested according to all relevant current CE guidelines, such as
electromagnetic compatibility and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
▼
▼
7 8
Fortress_MD3817 (Eng)_P7_Date: 17.4.13 Fortress_MD3817 (Eng)_P8_Date: 14.3.2014
148.5(L)mm
210(H)mm
148.5(L)mm
SPECIFICATION
Model No. KMD3817
Product name 2000W Hair Dryer
Voltage/Frequency 220 – 240V
Power 2000W
Dimension (W x H x D) 195(W) x 265(H) x 82(D)mm
WARRANTY
1. The product has 1 year warranty from the date of purchase.
2. The warranty shall not apply:
A. to any product subjected to misuse, alteration, act of God, improper handling,
improper transport, improper testing or unauthorized repair;
B. to cosmetic problems or defects which result from normal wear and tear under
ordinary use yet not affecting the performance or use of the product;
C. if the product is disassembled or altered;
D. to any packing, transportation, export / import tax or any related expenses.
3. CUSTOMER MUST PRESENT THE SALES INVOICE OR RECEIPT FOR 1 YEAR
WARRANTY SERVICES.
4. Please bring along the product and sales invoice or receipt to our services center for
warranty services during office hour:
Address : Unit A, 20/F, Yip Shing Industrial Centre, No.19, Yip
Shing Street, Kwai Chung.
Service Hotline : (852) 2428 1500
Service Hours:
Monday-Friday : 9:00am - 6:00pm
Saturday : 9:00am - 4:00pm
Sunday & Public Holiday : Closed
5. To prevent circuit overload and fire, no more than one adaptor or one extension
unit should be inserted into a socket outlet. (Do not connect other appliances to
the socket outlet supplying an electric heater.) No adaptor should be inserted into
any extension unit or vice versa.
6. Stop using an adaptor or an extension unit or a socket if its socket holes cannot
firmly hold a plug if it is too hard to insert a plug into it.
7. This appliance must be plugged into a specific 220V socket with no less than 10A
provided. Please make sure the plug is fully plugged-in before use. Do not use any
adapter or extension cord; Never use the same supply socket for this appliance and
other appliances at the same time, in order to avoid damage to this appliance.
8. THE APPLIANCE IS FOR HOUSEHOLD USE ONLY.
ENVIRONMENT
Do not throw away the appliance with the normal household waste at the end
of its life, but hand it in at an official collection point for recycling. By doing
this, you help preserving the environment.
Fortress_MD3817 (Eng)_P9_Date: 14.3.2014 Fortress_MD3817 (Eng)_Blank_Date: 09.4.13
148.5(L)mm
210(H)mm
148.5(L)mm
9
IMPORTANT NOTICES
IN NO EVENT SHALL OUR COMPANY OR THE SUPPLIER BE LIABLE TO YOU OR ANY
OTHER PARTY FOR ANY DIRECT, INDIRECT, GENERAL SPECIAL, INCIDENTAL,
CONSEQUENTIAL, EXEMPLARY OR OTHER DAMAGES ARISING OUT OF THE USE OR
INABILITY TO USE THE PRODUCT (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR
INJURY, LOSS OF PROPERTY, BUSINESS PROFITS, BUSINESS INTERRUPTION) OR FROM
ANY BREACH OF WARRANTY, EVEN IF OUR COMPANY OR SUPPLIER HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO CASE SHALL OUR COMPANY
OR SUPPLIER’S LIABILITY EXCEED THE AMOUNT YOU PAID FOR THE PRODUCT.
Specifications, designs and dimensions are subject to change without prior notice.
/
