Chevrolet Trailblazer Owner Manual (GMNA-Localizing-U.S./Canada-
15328351) - 2022 - CRC - 2/10/21
18 Keys, Doors, and Windows
Other conditions can affect the performance
of the transmitter. See Remote Keyless Entry
(RKE) System 0 9.
Starting the Engine Using Remote Start
To start the vehicle:
1. Press and release
Q on the RKE
transmitter.
2. Immediately after completing Step 1,
press and hold
/ until the turn signal
lamps flash. If the vehicle's lights cannot
be seen, press and hold
/ for at least
four seconds.
When the vehicle starts, the park lamps will
turn on and remain on as long as the
engine is running. The doors will be locked
and the climate control system will operate
automatically if the vehicle has the
automatic system, or at the same setting as
when the vehicle was last turned off.
With an automatic climate control system
and if equipped with heated seats, the
heated seats turn on during colder outside
temperatures and shut off when the ignition
is turned on.
The rear window defogger and heated
mirrors, if equipped, turn on during colder
outside temperatures and turn off when the
ignition is turned on.
After entering the vehicle during a remote
start, press the brake and ENGINE START/
STOP with the transmitter in the vehicle to
drive the vehicle.
If the vehicle is left running, it automatically
shuts off after 15 minutes unless a time
extension has been done.
Extending Engine Run Time
To extend the engine run time by
15 minutes, repeat Steps 1 and 2 while the
engine is still running. An extension can be
requested 30 seconds after starting. The
engine run time can only be extended if it is
the first remote start since the vehicle has
been driven. Remote start can be extended
one time.
If the remote start procedure is used again
while the engine is still running, 15 minutes
will be added on for a total of 30 minutes.
For example, if
Q and then / are pressed
again while the engine is still running,
15 minutes will be added on for a total of
30 minutes.
A maximum of two remote starts or remote
start with an extension are allowed between
ignition cycles.
After the vehicle's engine has been started
two times using the remote start button or
a start with an extension, the ignition must
be turned on and then back off before the
remote start procedure can be used again.
Canceling a Remote Start
To manually shut off a remote start:
.
Press and hold / until the lamps
turn off.
.
Turn on the hazard warning flashers.
.
Turn the ignition switch on and then off.
Conditions in Which the Remote Start
Will Not Work
The vehicle cannot be started using the
remote start feature if the key is in the
ignition (Key Access) or if a transmitter is in
the vehicle (Keyless Access), the hood is
open, the vehicle is on, the hazard warning
flashers are on, the vehicle is not in P (Park),
two remote starts or a start with an
extension have been used, or there is an
emission control system malfunction.