Page is loading ...
1
Installation Instructions for
Slot Flush
980SLOTC
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low voltage electronic dimmer.
This instruction shows a typical installation.
1.0
F 1057M
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Ceiling
Remove the fixture screws located on the sides of the canopy using a screw driver, then remove the mounting plate from the canopy.
Install the mounting plate onto the electrical box with the two #8-32 screws provided.
Connect the fixture to suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the electrical box, mount the fixture
back onto the mounting plate, and reinstall fixture screws (reversal of step 1).
1
2
1A
Install the Fixture
3
4
5
6
1
© 2018 Lighting.All rights reserved.The " Lighting" graphic is aLBL LBL
registered trademark of Lighting. Lighting reserves the right toLBL LBL
change specifications for product improvements without notification.
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.lbllighting.com
A Generation Brands Company
SAVETHESE INSTRUCTIONS!
2
5
4
MOUNTING PLATE
FIXTURE
FIXTURE SCREW
3
/