Hex Wrench
Hex Screw
SSWTABLE, SSWTABLE36, SSWTABLE60, SSWTABLE72
Stainless Steel Work Table
Assembly Instructions
Place tabletop upside down on soft
cloth surface to prevent scratches.
Insert one leg into a corner support.
Locate the accessory bag and
remove the Hex screws and
Hex wrench.
Using the Hex wrench, loosely tighten
the Hex screws (with the HEX side
visible) into the corner support.
Each corner support requires two
Hex screws. Wait until the table is
completely assembled before
securely tightening each Hex screw.
After all four legs have been loosely
attached, lower the adjustable table
base and insert each leg through the
base holes.
The table base is adjustable.
Position it by raising or lowering it
along each leg. You may choose to
use the aid of a level.
Each corner support requires two
Hex screws. Wait until the table is
completely assembled before
securely tightening each Hex screw.
All four legs can be adjusted for
surfaces that aren’t completely level.
Rotate the plastic foot pad to compensate
for differences in floor surface.
Turn the table over AFTER
securely tightening each Hex
screw. Two people may be
required to rotate the table.
Contact: info@sportsmanseriesbrand.com http://www.sportsmanseriesbrand.com 888-287-6981
1 2 3
4 5 6
7 8 9
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Craftsman 113.2472T0 User manual
-
Wen 3912 User guide
-
NewAge Products 65003 Installation guide
-
-
-
RIDGID SP6263 User manual
-
-
-
-
REXON BT2504R Owner's manual
