Page is loading ...
1815-305 Mid-Range Card Reader
Mount the card reader using the plastic spacer and hardware provided as shown in the diagram
below. Mount the spacer to the mounting post (mounting surface) first, then mount the card reader.
Read range will be substantially reduced if the reader is installed on metal surfaces without the
spacer. Read range can also be affected by RF interference from power supplies, electrical and
electronic equipment, some types of lighting, computers and monitors, motors and generators.
8-32 x ΒΌ Weld Nut
(4 places)
10-32 Carriage Bolt
(4 places)
10-32 Nut
(4 places)
Mounting Post
(or other metal surface)
Card Reader
Spacer
+ 12 VDC
Common
Wiegand Data 0
Wiegand Data 1
LED
Beep
Red
Black
Green
White
Yellow
Blue
Specifications
Power: +12 VDC Regulated
Current: 50-450 mA
Operating Frequency: 125 KHz
Maximum Read Range: 30 Inches
Output Format: 26-bit Wiegand
Dimensions: 9.38 x 9.38 x 1.38 inches
8-32 Screw
(4 places)
1815-161-A-3-12
/
