2. Toro
  3. LED Light Kit, TimeCutter HD Riding Mower

Toro LED Light Kit, TimeCutter HD Riding Mower Installation guide

  • Hello! I've reviewed the installation instructions for the Toro LED Light Kit model 147-8757. It provides step-by-step guidance on installing the light kit on TimeCutter Max or TITAN Riding Mowers. I'm ready to answer your questions about its specific installation process, including differences between gas and electric models!
  • What tools are required to install the light kit?
    Do instructions differ for gas and electric models?
    Where can I get installation assistance?
Form No. 3465-864 Rev A
LED Light Kit
T imeCutter
®
Max or TIT AN
®
Riding Mower
Model No. 147-8757
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty .
Use
No parts required
–
Prepare the machine.
Light bracket 1
Hex-washer-head thread forming screw (5/16
x 3/4 inch)
2
LED light 1
Hex-washer-head screw 2
Wire harness 1
Cable tie
1
Install the LED Light Kit.
Preparing the Machine
Gas Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the P ARK position.
4. If equipped, engage the parking brake.
5. Shut of f the machine and remove the key .
6. W ait for all moving parts to stop.
7. Allow machine components to cool.
Electric Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the NEUTRAL position.
4. Engage the parking brake.
5. Shut of f the machine and remove the key .
6. W ait for all moving parts to stop.
7. Allow machine components to cool.
8. Remove the battery packs from the machine.
© 2023—The T oro® Company
81 1 1 L yndale A venue South
Bloomington, MN 55420
Register at www .T oro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3465-864*
Installing the LED Light Kit
Note: For installation assistance, contact an
Authorized Service Dealer .
1. Install the light bracket onto the front of the
machine using the 2 hex-washer-head thread
forming screws (5/16 x 3/4 inch).
g468945
Figure 1
2. Install the light to the light bracket using the 2
hex-washer-head screws.
g468946
Figure 2
3. Connect the wire harness to the back of the
lights and secure the harness to the front frame
rail using the harness clip.
g468947
Figure 3
1. Harness clip
4. Route the wire harness along the right frame
rail, while securing the harness clips to the rail.
g468948
Figure 4
5. Cut the cable tie securing the auxiliary connector
of f the main harness and remove the auxiliary
end plug.
6. Connect the light harness to the auxiliary
connector .
7. Secure the kit wire harness to the machine wire
harness using the cable tie.
8. Electric machines only: install the batteries.
2
/