2 Manual RS.8A.B1.02 © Danfoss 6/1999 AKA 242
AC-RDT
How to assemble the components
1. If control panels type AKA 21 are connected to the DANBUSS Data Communication, they must be disconnected
2. Connect the service gateway to the PC
3. Connect the service gateway to the DANBUSS Data Communication (the cable with female coupling)
4. Connect the supply voltage to the service gateway (polarity is immaterial)
5. Connect the supply voltage to the PC
6. Start the AKM programme
This is what you need
CP
yawetagecivresdnaCPneewtebelbaC
roelop-9-elop-9
elop-52-elop-9
srebmunedoC
:9-9 4902B480
:52-9 6902B480
242AKAepytyawetagecivreS
dna12AKAhtobrofsnoitcennocelbaC
.dekcapyberaSSUBNAD
sahyawetagehT.deriuqeryrettaboN(
.)rebmemerotgnihton
rebmunedoC
4622B480
remrofsnarT
)yawetagecivresehtotylppusrewoP(
:gniwollofehtseriuqeryawetagehT
%51-/+.c.dro.c.aV21ot9
AV5.2
lacolruoymorfremrofsnartehtyubnacuoY
.relaed
12AKA
lortnocaeriuqeroslayamuoysesacemosnI
.12AKAepytlenap
rebmunedoC
2002B480
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alternations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respecitve companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
DANBUSS
AKA 21
PC