Lang 36S-HS Installation guide

Lang Manufacturing Company 6500 Merrill Creek Parkway Everett, WA 98203

Phone: 425-349-2400 Fax: 425-349-2483

36S-HS HIGH SHELF

INSTALLATION INSTRUCTIONS

NON - PRE-DRILLED RANGES

If the range that the Hi Shelf is to be installed on has been

pre-drilled by the factory

proceed to the next section -

Pre-drilled Ranges

If the range has not been pre-drilled, continue with this

section

Place the High Shelf on top of the range so that the back

of the range is flush with the back of the High Shelf.

Mark the five holes in through the flange in the High Shelf

onto the top of the range.

Mark the six holes through the sides of the High Shelf

onto the side of the range.

Remove the High Shelf from the range.

Drill all eleven holes using a # 27 drill bit.

Place the High Shelf back on top of the range and install

all sheet metal screws.

PRE-DRILLED RANGES

Place the High Shelf on top of the range so that the holes in the High Shelf line up with

the holes in the range and the backs are flush.

Install five 10-24 x 1/2 Truss Head Machine Screws through the holes in the back flange

of the High Shelf into the top of the range.

Install three 10 x 1/2 Sheet Metal Screws through

each

side of the High Shelf into the

side of the range.