8
8
9
65
Instructions For Use
figure 3
figure 1
figure 2
adjustable angle
locking knob
locking knob
How to open the umbrella
1. Push the curved umbrella frame to the top as shown in figure 1.
2. Tighten the locking knob to lock the umbrella position as shown
in figure 2.
3. Turn the crank clockwise to open the umbrella.
4. Loosen the adjustable angle locking knob to angle the umbrella
canopy to desired position (figure 3).
5. Now enjoy your new offset umbrella.
How to close the umbrella
1. Turn the crank counterclockwise to close the umbrella
2. Loosen the adjustable angle locking knob and pull the curved
umbrella frame down to the bottom.
3. Tie the umbrella to the pole.
Please close the umbrella and tie it securely in severe weather or
strong winds.
open
close
Warranty
Two Year Limited Warranty
All furniture manufactured and sold by Aldi is warranted to
the original purchaser against defects in workmanship and
materials, provided the item was a factory sealed at the time
of purchase and is maintained with care and used only for
personal purposes. If a product fails during the first two years
from date of purchase under the terms of our limited war-
ranty, the manufacturer will replace the item at no charge. If
the item was purchased as an open box, previously returned,
or clearance item, the purchaser may obtain replacement
parts for a nominal cost if parts are still available. After two
years, it will be the original purchasers’ responsibility to pay
for freight and packing. The manufacturer reserves the right,
in the case of discontinued or out of production models, to
replace with an item of similar quality. Warranty is to the
original purchaser and is non-transferable.
Note: You must retain original receipt to obtain
warranty!
Frame
The frame is warranted against defects in materials and workman-
ship from the date of original purchase. Damage to frame or welds
due to commercial use, improper assembly, exposure to water and
sub-freezing temperatures, and/or abuse are not covered.
Steel components are treated with rust inhibiting paint that protects
them from rust. However, due to the nature of steel, rusting will
occur if the protective coating is scratched. It is recommended that
care be taken when assembling and handling the product in order
to prevent the paint from being scratched. If scratching or damage